Design of Plastic Piece Parts
This paper describes a computer assisted design process originally developed at the University of Wyoming and now implemented in commercial software. In order to address the need for broadly...
Stereolithography
Stereolithography is a three-dimensional printing process which produces accurate copies of CAD solid or surface models directly from CAD data. The process uses a moving laser beam, directed...
Gamma Exposure from Rn Progeny in GAC Units
An investigation into the gamma exposure rate generated by granular activated carbon (GAC) water treatment units focused on ten sites that covered a range of source radon (Rn) in water...
Using Borosilicate Glass as a HLW Storage Medium
There is growing concern over the quality of present high level waste management techniques. Instances of nuclear accidents and contamination at nuclear waste sites in the United States...
Conducting a Waterline Corrosion Evaluation
A study has been conducted to determine the level of corrosion activity occuring on the U.S. Navy's potable waterlines on Guam. The study evaluated soil parameters including...
Loss of Carrying Capacity in Pipes?Transporting Softened Water with High pH
The increase in pipe roughness and loss in carrying capacity for water mains carrying high pH water is documented with over 20 field tests conducted in Austin, Texas. The data show that...
Low-Level Waste Disposal Design: An Overview
Low-Level radioactive waste disposal is regulated by several agencies. Mixed waste, which is both radioactive and chemically hazardous is regulated by two agencies with potentially different...
The Utilization of a Deflocculant to Decrease the Permeability of a Clay Liner
A hazardous waste landfill was completed in Oklahoma during 1988. The clay liner was constructed to fulfill the RCRA requirements for permeability of equal to or less than 1E-07 centimeters...
Modeling a Multiple Well Groundwater Supply System
The paper is concerned with the simulation of existing groundwater supply systems. This encompasses the delivery of the groundwater from the wells to the water treatment plant, including...
Drainage of Landfill Covers and Bottom Liners
This paper presents two new tools for preliminary evaluation of drainage-system designs. The first is a set of equations that define the saturated-depth profile for steady drainage over...
Ground Water Recharge and Use, Ventura County, California
For more than 60 years United Water Conservation District and its predecessor district have recharged seven ground water basins in Ventura County, California with more than 2,500,000 acre...
Pressure Relief Design Around Pumping Plants
Hydraulic transient protection for an irrigation pipeline pump station can include optimized operating procedures, or design of surge relief equipment such as surge relief valves, and...
Locating and Sizing Air Release Valves on Irrigation Systems
This writing is directed to persons involved in irrigation systems and describes the usage of air release and vacuum valves. Principles described are applicable to many other piping systems,...
Experience With a Water Distribution System Model
The City of Santa Cruz has a water distribution system covering approximately 30 square miles (78 km2) and serving 75,000 people. The population...
Instability of Bed-Surface Composition Due to Sorting Process in a Stream Composed of Sand and Gravel
Wavy patterns of sorting are often observed in a stream composed of sand and gravel, and they are regarded as instability of bed-surface composition due to selective bed-load transport...
Sediment Transport Modelling from Grain Size Data
Grain-size analysis can be useful in determining some of the hydrodynamic aspects of the evolution of a natural sand body. The suite statistics approach minimizes single-sample anomalies...
Sediment Transport in Hyperconcentrated Flows in Sand-Bed Streams
This study advances the understanding of sediment transport of bed material discharge in sand bed streams through application of recently developed theoretical concepts related to the...
The Area of Scour Hole Around Bridge Piers
The study is focused on what parameters determine the area of scour hole around bridge piers. An analytical study based on momentum principle has been used to reveal the variables involved...
Hyperconcentrations, Mud and Debris Flows?A Summary
Brief descriptions of the properties of mud and debris flow and hyperconcentrated stream flow materials and their importance to the descriptions and modeling of these flows are presented....
Selective Erosion: A Key Problem in Numerical Modelling of River-bed Changes
In capacity-controlled sediment transport of alluvial rivers the so-called 'hiding factor' determines the stability of the various grain-size fractions. The paper...
Return to search