IVHS-Organizational Structure and Staffing
Continuing technology advances in IVHS present challenges that many states are unable to meet with their current staffs. Only a few states have recognized the need to plan the need to...
An Integrated Route Assignment and Traffic Simulation System with a Massively Parallel Computing Architecture
This research presents two critical issues in the development of an integrated route assignment and traffic simulation system of ATMS-ATIS applications. The first issue addresses the conceptual...
Lag Relations for Semi-Arid Regions and Urban Areas
The use of synthetic unit hydrographs often requires the estimation of lag or other travel time parameters. Several procedures are available for estimating such unit hydrograph parameters....
Lessons from Hurricane Andrew's Effects on Hydraulic Structures
Documentation and description of Andrew's effects on open channels and other hydraulic structures in South Dade County, Florida, are presented, based on observations made during field...
A Computer System to Operate Coastal Structures
The Central and Southern Florida Flood Control Project (C&SF) was designed and built by the U.S. Army Corps of Engineers and is operated and maintained by the South Florida Water...
Hydraulic Modeling of Alluvial Plains (Slopes) and Alluvial Fans Using DAMBRK
The design of hydraulic structures such as bridges on distributary flow areas and alluvial fans require methods that can adequately determine discharges at the structures. Flow conditions...
Non-Intrusive Crack Detection in Clay Landfill Cover Liners
Laboratory and field studies were conducted to demonstrate that the azimuthal variation in electrical resistivity can be used to indicate the presence of cracks in clay systems. Laboratory...
A Semi Passive Nutrient Injection System for In Situ Bioremediation
A permeable cutoff wall is installed across the path of a contaminant plume. The water in the wall can be amended with the desired nutrient solution using pumping and injecting wells within...
A Review of Surface-Groundwater Interaction Models
Surface-water and groundwater systems are in continuous dynamic interaction. Processes such as infiltration from surface waters and precipitation, the discharge of groundwater to surface...
Model Structure Validation in Groundwater Modeling
Structure equivalence models (SEM), a new concept in groundwater modeling, have been developed to assist in groundwater planning and management. Using SEM, the engineer is able to satisfy...
Linear Pertubation Model: An Application to Tanzanian Catchments
Floods are still a problem to many countries in the world todate. Floods do cause damage to property and sometimes loss to human life. Flood control measures by structural and non-structural...
Overland Flow Resistance Estimation from Small-Plot Data
The correct application of physical process models, such as the kinetic wave approximation to shallow overland flow, is dependent upon selection of appropriate values for parameters which...
Getting Along: The Geotech and the CM
The opinions of geotechnical engineers are usually respected within a consulting firm, but when such a specialist gets out in the field, he or she is seen as merely part of the backup...
Lead is a Four-Letter Word
New regulations and strict enforcement make it difficult and expensive to remove lead-laden coatings from steel structures. Lead-based primers and paints are not considered hazardous as...
Short-Span Bridge Solutions
Large bridges get most of the headlines, but the nation's huge network of small bridges (many with spans of less than 25 ft) may be more in need of replacement. Age, corrosion,...
Nonlinear Hydrodynamic Pressures on Dam Faces with Arbitrary Reservoir Shapes
A finite-difference method was used to calculate the nonlinear hydrodynamic pressures acting on the rigid dam faces during earthquakes. The geometry of the reservoir is in a realistic...
The Coyote Dam Outlet Works Replacement Project: Hazard Reduction
The Santa Clara Valley Water District's Coyote Dam faced three major concerns: siltation of the existing outlet; a fault that crosses the existing outlet pipe; and the dam toe and the...
Hydraulic Performance of Culvert End Sections Designed for Collision Safety
A type of end section for pipe culverts that was designed for collision safety has some favorable hydraulic characteristics. These safety end sections are long and narrow with large steel...
Compacted Spillway
The compacted spillway (CSW) refers to a spillway accompanied by jets located on its face to dissipate the excess energy. The (CSW) has a standard ogee profile with three jets located...
Equations to Predict Critical Submergence at Horizontal Hydraulic Intakes
The formation of free surface vortices at hydraulic intakes can disrupt operation and damage machinery. It is also a serious safety concern. Theoretical investigations and laboratory tests...
Return to search