Bureau of Reclamation Downstream Hazard Classification
An overview of the downstream hazard classification process used by the Bureau of Reclamation (Reclamation) and other U.S. Department of the Interior (DOI) agencies for the safety of dams...
Using Threat to Life Studies to Guide Dam Safety Decisions
Ensuring that Bureau of Reclamation (Reclamation) dams do not present unacceptable risks to public safety, prosperity, and welfare serves as a primary objective of Reclamation's Safety...
Economic Aspects of the Bureau of Reclamation Safety of Dams Program
The paper briefly examines economic aspects of the Bureau of Reclamation (Reclamation) Safety of Dams (SOD) program evaluation process. Procedures described include the downstream damage...
Scour Prediction Model at Bridge Abutments
A model to predict local abutment scour is presented. The model is based on a large number of laboratory experiments over the past half century. The dependent variable, a ratio that includes...
Bridge Abutment Scour in Compound Channels
Experiments are reported which quantify the effect of channel geometry on local scour at abutments for bridges crossing compound river channels. The channel geometry effects are represented...
Design of Riprap Stilling Basin for Overhanging Pipe
The rock rip-rap basin is the most common and economical method of handling the problem of scour at a pipe outlet. The advantage of the method is speed of construction, absence of the...
Bank Stability Analyses Versus Field Observations
The concept and process of stream bank stabilization design through the development and use of limiting stability curves for the comparison of existing bank height/angle combinations to...
Computation of Flow Past a Cylinder Mounted on a Flat Plate
The surface shear stress distribution in the vicinity of a circular cylinder - mounted normal to a rigid flat plate - produced by the three-dimensional flow past it, is investigated numerically...
The Influence of Exposed Footings on Pier Scour Depths
Data compiled from past test efforts are combined in this article with the results of two new flume test studies. The combined material, presented graphically, suggests a method for adjusting...
Operational and Structural Optimisation of Hydraulic Structures for Light Liquid Removal
The removal efficiency of light liquid separation schemes is determined by the hydraulic inflow conditions, the inflow fluid properties and the separator hydraulics. The relating set of...
The Study of Riprap as Scour Protection for Bridge Abutments
The purpose of this paper is to provide design guidelines for riprap protection of spill-through and vertical-wall abutments situated in floodplains. With the benefit of laboratory experiments,...
Erosion Protection at Hydraulic Structures: A Report From the Task Committee
In 1991 the ASCE Hydraulics Structures Committee formed a task committee on Erosion Protection at Hydraulic Structures. The purpose of the committee is to determine current practices in...
An Assessment of Fish Entrainment and Impingement Potential for an Offshore Cooling Water Intake in a Tropical Bay
Fish entrainment and impingement potential were assessed for a proposed cogeneration facility on the west coast of Puerto Rico that will withdraw cooling water using offshore intake structures....
The Control and Monitoring of Local Scour at Bridge Piers
A series of flume experiments revealed a possible method of reducing local river bed scour at bridge piers, thereby, reducing the risk of bridge failure. Three prototype schemes were installed...
Comparison of Theoretical and Historical Scour
As part of scour assessments at approximately 120 stream crossings on the New York State Thruway, subsurface investigations were performed at all structures and, in some instances, locations...
Fluid Mechanics Aspects of Ocean Outfalls
Prediction of the environmental effects of ocean outfalls requires understanding of some complex fluid mechanical phenomena. These include the dynamics of merging plumes in flowing, density-stratified...
General Implicit Representation of Hydraulic Structures in Numerical Flow Models
Effects of hydraulic structures (such as culverts, bridge openings, or gates) can be simulated in numerical surface-water-flow models. Generally the scale and dimension of the numerical...
Low-Flow Habitat in Flood Control Channels
A critical phase in the life cycle of many riverine species in flood control channels is during low-flow periods when the quantity and quality of available habitat diminishes. However,...
Bridge Hydraulic Design in Tidal Situations
The analysis of bridge hydraulics and scour potential in tidal waters, in comparison with inland rivers, requires consideration of various additional factors. This paper condenses a simplistic...
Hydraulic Modeling of Fish Screens
Hydraulic model studies coupled with available knowledge of fish behavior can be important component in the development of fish-screening systems. To reproduce in a model the flow field...
Return to search