Sediment Removal from Sand Hills Aqua Farms Using a Sediment Evacuation Pipeline System
Reservoir sedimentation continues to deplete the world's reservoirs of valuable storage capacity. Several reservoir sediment removal techniques have been successful in regaining...
Dynamics of Protective Coatings to Limit Cavitation Damage
Cavitation implosions inflict a very high impact stress on turbine blades and turbine liners. One strategy for limiting the impact on the turbine components is to overlay a protective...
New Interior Lining for Welded and Riveted Penstocks
Pacific Gas and Electric Company (PG&E) has 73 hydroelectric power facilities installed throughout its distribution system. Each of these facilities has at least one penstock,...
Evaluation of Thermoplastic Drainage Pipe Designs in Europe and North America
The last 10 years have seen significant increase in the use of plastic pipe for drainage systems in North America in comparison to Europe. Many plastic pipe products have included corrugations,...
Field Fabrication of Reinforced Plastic Pipes
A new technology allows fabrication of reinforced plastic pipe in the field, or the lining of existing pipe. The plastic used can be selected to meet job and site requirements. The reinforcing...
Predicting Incipient Fluidization of Fine Sands in Unbounded Domains
Fluidization systems in the coastal environment consist of a water pumping system and a source pipe buried in or near a tidal inlet to maintain a channel or to aid in sand bypassing. If...
Sediment Transport Measurements in the Nile River at Bani Mazar
Measurements of sediment transport on the Nile River were conducted at Bani Mazar (200 km South of Cairo) during high and low water stages. Bed-load and suspended-load transport rates...
Hydraulic Aspects of Grade Control Structures
This paper describes the function of grade control structures. The primary purpose of a grade control structure is to maintain or establish a desired bed elevation in a channel. Basically...
Bed Load Roughness in Supercritical Flow
A supercritical concrete channel is proposed for Mission Creek located in Santa Barbara County, California. The proposed channel may transport gravels and cobbles as bed load during large...
Design of Groins on the Middle Rio Grande
The Albuquerque Projects Office of the Bureau of Reclamation wanted to use groins in place of revetments at two sites on the Rio Grande. The Bureau of Reclamation has limited experience...
Incipient Motion Criteria Defining Safe Zones for Salmon Spawning Habitat
Approximately 70% of the City of Seattle's water supply is drawn from the Cedar River. Between 200,000 and 400,000 sockeye salmon spawn annually in this partially dewatered...
Existing U.S. Standards in Hydraulic Engineering
The Task Committee on Recommendations for Standards in Hydraulics confined itself to topics that are used in hydraulic computations or design. Thus numerous standards related to size,...
Model Study of an Intake Structure
To increase the delivery capacity of an existing gravity-feed water supply pipeline in Orange County, California, modification of the existing structure and placement of a booster pumping...
An Integrated Model for Fate and Transport of Oil in Rivers
An integrated oil spill model for microcomputers is developed for simulating fate and transport of spilled oil in rivers. This model can simulate the oil slick transformation in transient...
Numerical Model Development for Oil Spill Dispersion into the Marine Environment
A 3-D oil spill model was developed to study the behaviour of heavy spilled oil in the sea. The model could describe the behaviour on the spilled oil on the sea surface, throughout the...
TransAct: An Interactive Transient Analysis Program for Pipelines
The program TransAct is designed to analyze a wide range of transient responses that may have been caused by a complex combination of control actions. For example, there may be the simultaneous...
A Study of Friction Factor for Flow in Gravel Bed Channels
For many years practicing engineers have faced the problem of predicting the resistance to flow in channels with rough surface. Flow in channel is a complex interaction between surface...
Calibration of Beni-Mazar Movable Bed Model
A sand-bed model representing a reach of the Nile River was constructed to study alternative solutions to maintaining the navigation channel. Flume tests were carried out first to determine...
Development of Standards for Slipform & Jumpform Works
Review of past work indicates substantial effort has been made to publish construction standards and guidelines for slipforms but published material pertaining to jumpforms is scarce....
Temporary Structures for Protection and Access
Temporary Structures in Construction Projects (TSC) are utilized for three (3) purposes A. Support (of the structure being built or adjacent structures or utilities) B. Protection (of...
Return to search