Parametric Study of Cable-Stayed Bridges Response Due to Traffic-Induced Vibration
The dynamic response of long-span cable-stayed bridges due to moving traffic loads is investigated utilizing three-dimensional models. Modal analysis is conducted using the deformed dead-load...
Linear and Nonlinear Finite Element Analyses of RC Skewed Slab Bridges with Integral Wall Abutments
The design of rigid-frame skewed slab bridges is complicated by higher shears and moments near the obtuse corner (see Fig.1). While the finite element method can be used to compute these...
An Efficient Analysis of Framed-Tube Structures
An efficient model for analysis of framed-tube systems is proposed in this study. The proposed model can represent the interaction between plane frames consisting the tube system. Analysis...
Nonlinear Dynamic Analysis of Single Point Moored Buoy Under Wave and Current Loadings
In this study, a single point moored spherical buoy under wave and current loadings is analyzed in the time domain considering time memory effects. Geometric nonlinearity of the mooring...
Nonlinear Dynamic Analysis of Structural Frames Using Reduced Order Models
In order to provide more realistic and economical design of large structures it is necessary to perform analyses which take into account both material and geometric nonlinearities. Unfortunately,...
A Reduced Order Model for the Seismic Analysis of Building-Soil Systems
A finite element based, reduced order, numerical model has been developed for the nonlinear analysis of building-soil systems. The reduced order system model employs an equivalent continuum...
Three-Dimensional Analysis Model for Complete Masonry Buildings
For the predictive and diagnostic analysis of the complete nonlinear response of masonry buildings to seismic load input, a 3-D finite element model is under development at UCSD. The model,...
Interactive Buckling Analysis of Stiffened Shells Using Pregnant Sheel Elements
Two distinctive modes of failure dominate the failure of stiffened plates and shells, viz. the short-wave local mode and the long-wave overall mode. A new finite element technique which...
Buckling of Cylindrical Storage Tanks Due to Unsymmetric Lateral Wind Load
Non-linear finite element analysis is used to study the elastic stability of cylindrical storage tanks subjected to unsymmetrical loads. These cylindrical shells are assumed to be fixed...
Finite Element Analysis of a Highway Bridge Hinge
A highway bridge hinge is a very important element in bridge design. It releases thermal stresses that may be developed in the superstructure or the substructure of a bridge. A common...
Inelastic Behavior of Noncompact Steel Bridge Girders
This paper highlights the results from one of several finite element studies of the inelastic moment-rotation behavior of continuous-span non-compact bridge girders at interior-pier locations....
Dynamic Response of Variable Height Retaining Walls
A full-scale dynamic test was conducted on a 140 ft long reinforced concrete retaining wall. The observed resonant configurations were similar to those of a cantilever plate and showed...
Ambient Vibration Survey: Sunshine Skyway Bridge
An ambient vibration survey of the Sunshine Skyway Bridge was performed. The goal of this survey was to provide field data on the dynamic characteristics of the structure to corroborate...
Numerical and Centrifuge Modeling of an Arch Dam on Jointed Rock
This paper addresses the stability of an arch dam built on highly fractured argillite. A large concrete thrust block combined with a wing dam forms the left dam abutment. The last FERC...
Three-Dimensional Stability Analysis of Carpenter Dam
This paper describes the three-dimensional stability analysis of Carpenter Dam. The presence of keyed construction joints between dam monoliths at Carpenter Dam can significantly affect...
Evaluation of Rehabilitation Needs for Hydraulic-Fill Dam
This paper describes the application of analytical methodologies developed for seismic stability analysis of dams in the western U.S. (particularly the Lower San Fernando Dam in Southern...
Experience in Modeling for Environmental Physics and Biogeochemistry
This report is a short review of the author's personal experience on phys.-math. and system-logical modeling of migration and transport processes (MTP) of radionuclides, trace-elements...
The Results of Near-Field Thermal and Mechanical Calculations of Thermal Loading Schemes
Two waste emplacement schemes, borehole and in-drift, are under evaluation as potential repository drift geometries for the Yucca Mountain Site Characterization Project. Calculations were...
Investigation in 3-D of Stress Distribution in a Circular Tunnel and Vertical Emplacement Holes Due to Thermal and Overburden Loading in Tuff
Thermal stress and displacement analysis using two 3-D finite element models, one having a course mesh and one having a highly detailed mesh are presented. Results are compared to those...
Critical Stresses in Nuclear Waste Container Under Normal Handling Conditions
Critical stresses in the pintle, flat tophead, canister shell, the bottom plate and in the weldment of a high level nuclear waste canister are evaluated under a variety of static and dynamic...
Return to search