Fluvial Hydraulics of Streams and Mountain Rivers with Mobile Bed
The local hydraulic conditions concerning the incipient motion of the bed material in mountain streams are considered. Results of measurements carried out by using the radioisotope tracer...
Some Benefits of Grid by Number Sampling
Describing the overall sediment composition of gravel-bed river reaches and depositional bars is a difficult problem due to spatial variations in the sediment size. Past research has focused...
Effects of Particle Shape on Bedload Transport
The effects of particle shape on bedload transport in gravel-bed streams are examined using a similarity approach and fractional transport analysis for data from Piceance Creek, Colorado,...
Bed Load Prediction in Steep Mountain Rivers
The characteristics of the stream channel morphologies in a very steep mountain ravine are explained by the data obtained through the longterm field observation. The bed load transportation...
Step Pool Geometry and Flow Characteristics in Low-Sediment-Storage Channel Beds
Data from two small ephemeral streams in Israel indicate that step pool geometry in bedrock channels is similar, in its salient features, to that in alluvial channels. For steep (>0.10)...
Estimating Local Bed Shear Stress in Large Gravel-Bed Rivers
The local bed shear stress ?o1 cannot be directly measured and is typically estimated using flow observations in various theoretical or empirical...
Particle Dynamics and Bed Level Adjustments in a Mountain Stream
The focus of the study was the interaction of coarse bedload sheets with a near-static bed. At a critical discharge bed sediment was transported from upstream sources through the study...
Coarse Sediment Transport and the Maintenance of Fish Habitat in the Upper Colorado River
An analysis of the relation between discharge and boundary shear stress is presented for an alluvial reach of the Colorado River near Grand Junction, CO. The analysis indicates that the...
Velocity Control Rings for RC Pipe on Steep Slopes
This paper discusses the use of internal concrete rings to reduce velocity and concrete erosion for reinforced concrete pipes on steep slopes in the Southern California area....
Sediment Transport in Sewers and Design Implications
Extended studies on sediment transport in sewers were conducted at the University of Newcastle upon Tyne and using this new as well as previously available data an attempt has been made...
Laplace Valve Stroking for Complex Piping Systems
LaPlace valve stroking to control water hammer is applied in complex piping systems with friction and without friction. Two types of system are analyzed. The law of operation of the valves...
Theoretically-Derived Regime River Width
The governing equations describing the motion of fluid and non-cohesive sediment particles in alluvial channels are combined to analytically determine the equilibrium surface width of...
Equilibrium Geometry of Channels with Cohesive Banks
An optimization model is used to assess the stability of gravel-bed rivers with cohesive channel banks and to determine the effect of the bank stability on the equilibrium hydraulic geometry....
Width Adjustment: Relative Dominance in Unstable Alluvial Streams
The mechanisms that control the relative dominance of width adjustment in unstable streams are described. Specifically, the role of the following factors affecting the fluvial environment...
Field Evaluation of the Sediment Transport Model Stream with a Bank Erosion Component
The graded sediment routing and stream bed evolution model STREAM of Borah, Alonso and Prasad was expanded earlier by incorporating a riverbank erosion component of Osman and Thorne. In...
Relation of Unit Gravel Discharge to Mean Velocity
In sand-bed streams, the unit discharge of sand varies approximately with the fifth power of the mean velocity and inversely with the median diameter of the bed sediment. Similar relations...
Bed Material and Numerical Modeling in a Gravel/Cobble Bed Stream
The characteristics of bed material in a cobble or gravel river and their use for numerical simulation of flushing flow needs are discussed. There are three types of bed material: 1) material...
Local Scour Potential for Large Bed Material with Shallow Tailwater Depth
Jet momentum acting on a bed particle and submerged jet diffusion theory were employed to derive scour prediction formulas in a plunge pool. Semi-theoretical formulas were suggested for...
Performance of Submerged Vanes for Control of Sediment in an Irrigation Canal
Removal of accumulated sediments from irrigation canals is necessary in order to maintain canal capacity. Removal of these sediments may be enhanced by directing and concentrating sediments...
Fortification of MMOC Models for Steep-Channel Flows
The Multimode Method of Characteristics(MMOC), designed to solve unsteady flows, is a new comprehensive scheme formulated by merging several individual characteristic schemes of the specified-time-interval...
Return to search