Tunneling a Bridge
Linking an addition to the Georgia World Congress Center in Atlanta required a pedestrian tunnel through a railroad embankment 100 ft wide and 40 ft high, with no disruption of train service...
Advances in Short Span Steel Bridges
Applying recent research to the design of short span steel bridges can lower their cost and maintenance. Such research involves improved limit state criteria, more uniform lateral load...
Jointless Bridge Decks
Deck joints in a bridge are the source of many problems over its lifetime. In time, chances are good the joint will leak, permitting water and salt to leak through. Often this leads to...
Tunnel Shotcreting�Strength in Fibers
Steel fiber reinforced shotcrete (SFRS) costs less, has a lower rate of rebound and allows modern excavating equipment to advance with fewer interruptions than conventional shotcrete....
Engineering for Steel Construction
Structural Steel Details: Comments on Divided Responsibility
Five readers responded to an article on responsibility for structural steel details published in
Reinforcing Roof Truss Frames Under Load
Without altering the roof structure of an industrial boiler plant, a long-span steel truss frame was modified in place to support heavier loads. The owners of an industrial boiler plant...
Coefficient of Variation of In Situ Tests in Sand
For a research project on the behavior of piles in sand for the United States Geological Survey and the Federal Highway Administration, ten sites were selected where detailed load tests...
Steel Girder Bridge Sets Record Length
The Veterans Memorial Bridge at Ottawa, Ill., is the longest plate girder, stringer type bridge in the country with spans of 385, 510 and 305 ft. Value engineering played an important...
LAX Takes Flight for the 1984 Olympics
LAX (the Los Angeles airport) had over two dozen contractors working on site to complete their $700 million improvement plan in time for the Olympics in July. They also came up with several...
Seismic Design for Highway Bridge Foundations
This paper focuses on the determination of stiffness characteristics of piles and pile groups. Both battered and vertical pile groups are considered. Recommended methods for determining...
Seismic Risk and Decision Analysis of Lifeline Systems
This paper provides general guidelines for performing lifeline seismic risk and decision analyses. Relevant input models are introduced as they support the performance of component and...
Performance of Water and Sewer Lifelines in the May 2, 1983 Coalinga, California Earthquake
Water supply and filtration systems for the City of Coalinga suffered little damage. The water transmission system suffered five breaks. The urban distribution system was disrupted, but...
Dynamic Response Correlation of Cylindrical Tanks
The May 1983 Coalinga Earthquake provided an opportunity to correlate earthquake performance of cylindrical liquid storage tanks with behavior observed in laboratory shaking table experiments....
Bridge
Named Outstanding Civil Engineering Achievement of the Year, the Luling-Destrehan Bridge across the Mississippi River, twelve miles north of New Orleans, has a 1,222 ft. main span that...
Retaining Wall
The foundation of this off-ramp in Manchester, New Hampshire is made up of end-bearing piles and sloping rock anchors�an innovation that is unique to the United States. End bearing piles...
Bascule
The Columbus Drive Bascule Bridge in Chicago is one of the largest bascule bridges in the world with a 270 ft. span and 1l0 ft. width. Four welded steel box girders support each of the...
Computer-Aided Load Monitoring System for Nuclear Power Plant Steel Framing Structures
The design of nuclear power plant steel framing structures is a long and involved process. It is often complicated by numerous changes in design loads as a result of additions, deletions...
Probabilistic Seismic Analysis of a Nuclear Power Plant Steel Containment
Concern for the safety of nuclear power plants has motivated efforts to determine the statistical characteristics of the seismic resistance of steel containments under various types of...
The Response of Steel Containment Models to Internal Pressurization
To obtain insight and data on the response of containment vessels subjected to beyond design basis accidents, four 1/32 scale steel containment models have been subjected to internal overpressurization,...
Return to search