Pipeline Storm Behavior on Clay Soils
A series of transverse wave loading tests was conducted on a specially mounted section of pipe in a sediment-filled tank, to investigate the stability of unburied submarine pipelines under...
Corrosion Fatigue of Deepwater Offshore Materials
Evaluation of the fatigue life of offshore structures operating in depths of up to 10,000 feet (3,048 m) requires knowledge of the combined effect of axial and hydrostatic loading on the...
Skin Friction Distrtibutions on Piles in Sand
Presented in this paper are early results from an analytical investigation of the performance of a closed-ended pipe pile under monotonic axial loading in dense sand. The study was performed...
Review of API Guidelines for Pipe Piles in Sand
Most offshore structures are supported using steel pipe piles which are designed in accord with API Recommended Practice 2A. The guidelines for analysis of axial capacity of steel pipe...
Homopolar Pulse Butt Welding of API 5L Line Pipe
Homopolar pulse welding (HPW) is a welding process that is being investigated as a means to rapidly join API line pipe, having particularly great potential for application in deepwater...
Effects of Freezing on Impact Properties of RTM Composites, and Their Applications in Offshore Structures
Resin transfer molding is rapidly being acknowledged as the process with potential to create perhaps the purest form of a composite material as representative of the concept of `material-by-design.'...
Fiber Ropes for Ocean Engineering in the 21st Century
Recent advances in synthetic fiber ropes will greatly influence the practice of civil engineering in the oceans during the 21st Century. New fibers have moduli almost as high as steel...
Composites for Offshore Applications: A Multidisciplinary Education Program for the Marine Industry
Composites are increasingly being considered for offshore and other marine structural applications. Polymeric matrix composites reinforced with glass, carbon, and aramids offer substantial...
Use of X-Ray Computed Tomography in the Study of Marine Sediments
X-ray computed tomography (CT scanning) is primarily a medical imaging technique. When applied to marine sediments, it responds predominately to the spatial density distribution within...
A Fourier Series Solution to Bottom Roughness Induced Stresses During Pipe Laying
Often during installation, a subsea pipeline must be laid along seabed portions with rough profiles. The pipeline is forced by the bottom irregularities to bridge across consecutive protuberances....
Utilization of Waste Materials in Civil Engineering Construction
Industrial growth has increased the volume of wastes generated from energy production, mining, industrial processes and civil works. For economic and related reasons, the use of waste...
Manholes and Microtunneling
Contractors are for the Oakwood Beach Interceptor Sewer Project, on Staten Island, N.Y., were having difficulty. Glacial tills and a high water table made working 90 ft below the ground...
Put to the Test
In the construction industry, the concept of life-cycle cost applies not only to the infrastructure itself, but to the materials that go in to building that infrastructure. To improve...
Pressure Pipeline Design for Water and Wastewater
This committee report,
Cables and Anchorages
The following types of cables are generally used in cable stayed bridges: Parallel bars; Parallel seven wire strands; Parallel or semi-parallel wire cables; Locked coil strands and ropes;...
Decentralized Wastewater Management
With the discovery earlier this century that city squalor caused disease, we protected ourselves by piping raw wastes away. Later, when the discharge had transformed rivers into foul,...
Cellular Sheet-Pile Floodwall
Williamson, W. Va., flooded 37 times in this century, will soon be guarded by a $41 million, 4000 ft floodwall being built by the U.S. Army Corps of Engineers. A series of 41 circular...
Soil-Pipe Interaction During Frost Heaving Around a Buried Chilled Pipeline
The freezing of soil water around a buried chilled pipeline leads to soil heaving, which is affected by the presence of the pipe. This process may eventually cause pipeline failure. The...
Laboratory Methods for Preparing Low-Density Frozen Saline Soil Samples
Laboratory methods were developed for preparing low-density frozen saline soil samples with density values ranging from 85-110 lb/ft3. This range...
The Effect of Loading Rate on the Bending Strength of Alluvium Reinforced Ice
Traditional building materials are often less than ideal for construction in remote Arctic locations. Their mechanical properties may be degraded in extreme cold, and costs associated...
Return to search