Uni- and Bi-Axial Compressive Fatigue of Fiber Concrete
Fatigue behavior of fiber reinforced concrete is studied under uniaxial and biaxial loadings. The S-N curves and the cyclic deformations of fiber concrete are compared to those of plain...
Bond Strength of Fiber Reinforced Plastic Bars in Concrete
In this study, 27 beam specimens were tested to determine the bond strength of fiber reinforced plastic bars (FRP) in tension. The specimens were reinforced with #4, #6, or #8 FRP bars....
Measurement of Impact Fracture Toughness of FRC
Instrumented impact tests have been in use since the early eighties for studying the fracture characteristics of cement-based composites at high rates of loading. While significant progress...
Detection of Small Voids by Impact-Echo and Signal Processing
The Impact-Echo method was used to detect slab thickness, presence of small voids and reinforcement locations in a concrete slab. Studying the frequency response of the slab, it is possible...
Evaluation of High Strength Concrete by the Break-Off Method
The reliability of the Break-Off method to test inplace high-strength concrete is investigated. A total of 188 Break-Off tests and 30 standard cylinder tests are carried out for this project....
Displacement Measurement by Laser Interferometry and Image Analysis
Laser holographic interferometry was used for the evaluation of displacement fields on concrete and fiber reinforced concrete specimens. Transmission holography was used to analyze mortar...
Lime-Fly Ash-Aggregate Base and Subbase Courses
This paper describes the use of lime-fly ash-aggregate (LFA) base and subbase courses for highway pavements. This type pavement course is considered as an alternate to cement treated bases...
Theoretical Prediction of Temperature Distributions in Airfield Runway Pavements Due to Aircraft Operation
The determination of this transient temperature distribution is important in predicting the thermal effects on pavements due to aircraft operation. In this research, heat exchange at the...
Compressive Strengths of Lean Concretes Containing Fly Ash
The compressive strength development of lean concretes containing fly ash was evaluated. Concretes were prepared at total cementitious materials contents of 423, 517, and 564 lb/yd3...
Stresses in Concrete Armor Units
This book is derived from a Seminar at the Waterways Experiment Station, Coastal Engineering Research Center, Vicksburg, Mississippi held on November 7-8, 1989. It presents a state-of-the-art...
Instrumenting for Eternity (Almost)
Prendergast describes the safety features and instrumentation for a low level radioactive waste disposal facility planned for Illinois. Federal law requires that each state or group of...
Commentary on Building Code Requirements for Masonry Structures (ACI 530-88/ ASCE 5-88) and Commentary on Specifications for Masonry Structures (ACI 530.1-88/ ASCE 6-88)
Seattle Swing
The swing bridge has long been out of favor in the U.S. because of the navigational hazard presented by mid-channel pivot piers. A consortium of engineers is updating the design to a state-of-the-art...
Replacing Bridge Decks
U.S. bridges last an average of 68 years, their decks 35 years. But few bridges have been built with provisions for future deck repair, the only criterion being lowest first cost. During...
Serviceability and Durability of Construction Materials
The proceedings of the Materials Engineering Congress held in Denver, Colorado from August 13-15, 1990 include papers from 37 sessions that address the theme Serviceability and Durability...
Anchoring a Dam
To comply with Federal Energy Regulatory Commission requirements with regard to stability under a postulated Probable Maximum Flood, an extensive foundation investigation and stability...
Replacing an Urban Foundation
Baltimore's new subway extension will pass close to a 6-story reinforced concrete building near the Inner Harbor. Its timber piling foundation was threatened by the dewatering...
Structures Congress Abstracts 1990
Abstract only. The following themes are included: Rehabilitation and future challenges, Bridges, Earthquake engineering, Dynamic loads on structures, Metals and composite construction,...
Development of Hydraulic Structures
The Bureau of Reclamation was established in 1902. Since that time, Reclamation has constructed more than 220 dams. Each dam, depending on its function, has two or more principal hydraulic...
A Hard Look at Concrete
Concrete has been looked upon as something fixed and unchanging, a generic, nondescript mass, But it demands specific engineering attention. Because many existing concrete studies are...
Return to search