Stress Wave Loading of a Tunnel: A Benchmark Study
Five different finite element or discrete element computer codes were used to solve a sequence of problems leading to the problem of stress-wave loading of a circular tunnel in a jointed...
Fast Foundation for Soft Clay
This article describes the detailed foundation work and high-capacity piling design for a flue gas desulfurization (FGD) retrofit system for the Lambton Generation Station in Ontario,...
Seismic Performance Behavior of Precast Concrete Beam-Column Joints
The experimental test program being conducted at the National Institute of Standards and Technology on 1/3-scale model precast concrete beam-to-column connections is summarized. The objective...
A Comparison of the Cyclic Performance of Bolted and Riveted Connections
As part of a larger project to investigate the performance of older steel frames, a comparative study of bolted and riveted T-stub connections was conducted. The study included connections...
High-Strength Concrete Joints Under Cyclic Loading
This experimental investigation was undertaken to check the validity for high-strength concrete beam-column joints of recommendations made by ACI-ASCE (American Concrete Institute-American...
Ductility Analysis of Overload and Settlement
The concept of sufficient ductility to avoid premature or brittle failures is gaining wide acceptance in structural engineering and is an important aspect in mitigating the consequences...
Seismic Resistance of Steel Fiber Reinforced Concrete Beam-Column Joints
This paper discusses the advantages of using steel fibers in seismic resistant beam-column connections. First, the effects of fibers on the various aspects of behavior of concrete are...
Rock Structure in Relation to Concrete Dams on Granite
Granite is often considered to provide an excellent foundation for a concrete dam and a great many dams are thus founded on granitic rocks. Although granitic rocks lack the bedding of...
Prediction of Embankment Dam Breaching for Hazard Assessment
Downstream hazard assessments for dams require prediction of 1) whether a breach could form, and 2) the hydraulic characteristics of the breach for use in calculations of discharge and...
Rehabilitation of a Toe Drain
Old or improperly designed toe drains can cause trouble for embankment dams. Toe drains installed without proper filtering can provide an easy course for internal erosion and piping of...
Experimental Evaluation of Reservoir Bottom Remediation Material
Open trenches developed through a compacted clay liner on the bottom of a reservoir. An experimental investigation has been conducted to evaluate the feasibility of using silt-sized, nonplastic...
Geotechnical Modifications at Meeks Cabin Dam
This paper presents a summary of the geologic and geotechnical evaluation of a potential piping deficiency identified at Meeks Cabin Dam as well as description of remedial measures and/or...
Installation and Routing of Critical Embedments at the Hanford Waste Vitrification Plant
During the preliminary design phase of the project, a study was conducted to develop concepts for routing embedded piping and conduit between the remote cells and the service corridors...
Modeling Storage Behavior in a Fractured Rock Mass
To represent single bore hole injection tests in fractured rock masses, a transient model has been implemented, based on a three dimensional stochastic description of the fracture network....
Global Approaches for the Nonconvex Optimization of Pipe Networks
Because the pipe network problem is nonconvex, two global search schemes, MULTISTART and ANNEALING, are employed to permit a local optimum seeking method to migrate among various local...
Pipe Network Optimisation Using Genetic Algorithms
A new optimization technique of generic algorithms has recently been successfully applied to pipe network optimization. In this paper a parametric analysis is carried out of the genetic...
Non Contact, Remote Sensing of Buried Water Pipeline Leaks Using Infrared Thermography
Subsurface water pipelines, sewer and buried utilities throughout America and the rest of the world range in age from hundreds of years old to brand new. They all have, however, one fact...
A Work Packaging Process Model for Petrochemical Plant Piping Construction
This paper presents a model for the current work packaging process for petrochemical plant piping construction. The basic foundation of the model is formed by identifying major decision...
The Building Code Desktop for Engineers?
Joint work in progress by John A. Martin and Associates and International Conference of Building Officials to develop an electronic building code information system is presented. This...
Stress Analysis in Concrete with Cooling Pipes
A substructure method of finite element analysis is adopted in this paper to simulate heat transfer and thermal stresses in a concrete dam. The massive concrete structure is cooled by...
Return to search