Settlement of Shallow Foundations in Sands Selection of Stiffness on the Basis of Penetration Resistance
The paper discusses the use of the formulae of the theory of elasticity to compute the settlement of shallow foundations in sands when subjected to static loading. Special emphasis is...
Pressuremeter Stress Relaxation Testing in a Permafrost Tunnel
In the spring of 1988, a geotechnical testing program was carried out in the U.S. Army CRREL Permafrost Tunnel, located at Fox, near Fairbanks, Alaska. In all, some thirty cone penetrometer...
Wave Equation Modelling of the SPT
The stress wave propagation in the Standard Penetration Test (SPT) is described in this paper. It is shown that the SPT is a complex dynamic system and that both force and motion measurements...
A Hybrid Expert System for Design with Geosynthetics
A prototype hybrid expert system is presented that selects geosynthetic materials and performs detailed designs for different geotechnical applications. An expert system is used to give...
An Expert System for Estimating Soil Strength Parameters
An expert system to aid in selecting shear-strength parameters for use in stability analysis was developed for use on a PC. It provides guidance in interpreting strength measurements and...
Soil-Cement Mixed Wall Technique
This paper introduces the soil-cement mixed wall technique and its applications for the installation of cutoff walls, excavation support walls and soil-crete columns for soil stabilization....
Stabilization of Collapsible Alluvial Soil Using Dynamic Compaction
The effectiveness of dynamic compaction for improving collapsible soils was evaluated under field conditions using full scale load tests performed on 1.5 m square footings. Tests were...
Jet Grouting?Uses for Soil Improvement
The frequency of use of any engineering technique depends mainly on the technical feasibility and economics of the system. In geotechnical engineering, the more problems a construction...
Group Efficiency of Piles Driven Into Sands: A Simple Approach
A simplified analysis for computing group efficiency of circular displacement piles in sands is presented. Pile installation is assumed to cause soil displacements in the horizontal direction...
Three-Dimensional Nonlinear Study of Piles and Simplified Models
In a recent study the authors examined the effect of the nonlinear behavior of soil on the axial and lateral response of one or two piles due to monotonic and cyclic pseudodynamic loading...
An Expert System for Preliminary Ground Improvement Selection
Ground Improvement is an area which has rapidly advanced in the past two decades. Most of the work has resulted from experience in field work. Thus experience has played a vital role in...
SOLES: A Knowledge-Based Soil Liquefaction Potential Evaluation System
A prototype computer program, SOLES has been developed to evaluate the liquefaction potential of soil subjected to earthquake excitations. The program applies both rule-and algorithm-based...
Evaluation of Geotechnical Design Parameters by Expert System Techniques
This study refers to application of an artificial intelligence technique to evaluate geotechnical design parameters in the soil design definition. This complex evaluation is incorporeted...
Do Simplistic Methods of Foundation Design Produce Reliable Foundations?
Many foundations today are designed using deterministic (single value) analysis techniques which do not reflect the natural variability of soil properties. If the standard deviation and...
Settlement of Footings on Sands?Accuracy and Reliability
Twelve methods of estimating settlements of footings on sand were evaluated by comparing calculated settlements with measured settlements. Each of the methods was evaluated in terms of...
Reliability Analysis for Time of Travel in Compacted Soil Liners
Time of travel through compacted soil liners is difficult to predict because numerous factors confound the analysis. In this paper, the influence of spatial variability and uncertainty...
Geotechnical Engineering Design in the Age of the Modern Computer
Because geotechnical engineering requires that the materials and their configuration be investigated for each new project, the profession has always placed great emphasis on judgment....
Modification of
The response of piles in a rectangular group subjected to lateral loading has been analyzed using a three-dimensional finite element model to evaluate the effect of pile spacing on lateral...
Dynamic Testing to Predict Static Performance of Drilled Shafts Results of FHWA Research
The paper describes the preliminary results of recent research sponsored by the FHWA on predicting by relatively economical dynamic methods, the static capacity and performance of drilled...
Group Effect in the Case of Downdrag
A summary of the various techniques available to calculate downdrag forces on pile groups is presented. In light of all these existing techniques, a simplified method is recommended. An...
Return to search