Design of Protective Dunes at Dam Neck, Virginia
Dunes act as a primary coastal defense against inundation in the Netherlands and the Dutch Government has devoted considerable effort towards development of reliable procedures for the...
A Dual Approach to Low Frequency Energy Definition in a Small Craft Harbor
Low frequency wave energy in a small craft harbor is examined through comparison between a numerical model and a 3-dimensional physical model. A hybrid element steady state linear monochromatic...
Design, Construction, and Performance of a Baffled Breakwater
The Spud Point Marina breakwater is located within Bodega Harbor, a protected embayment on the northern California coast. Waves are attenuated by baffle panels hung between support piles....
57 Years of Coastal Engineering Practice at a Problem Inlet: Indian River Inlet, Delaware
This paper presents a review of Indian River Inlet's behavior in its natural state prior to jetty construction and summarizes the level of understanding of coastal processes and inlet-bay...
Use of Portable Simulator in Designing Channel Improvements for Port of Brownsville, Texas
The Port of Brownsville, located at the southernmost tip of Texas, serves as an import/export port for both southern Texas and northern Mexico. The proposed channel improvement project...
Naval Pier Foundation Design and Construction, Pearl Harbor, Hawaii
The paper presents a case study of foundation design and construction for a pier in Pearl Harbor. The study covers a review of site investigations, laboratory testing, pile selection and...
Dutch Experience on Design of Dikes and Revetments
The increased demand for reliable design methods for protecting structures has resulted in The Netherlands in preparing a set of design guidelines for design of dikes and revetments. The...
A Design Manual for Coastal Fluidization Systems
This paper summarizes a recently completed design manual on fluidization systems to manage sand in the coastal environment for sand bypassing at inlets and harbor mouths and for creating...
Coastal Engineering Design Codes in the Netherlands
Dutch research strategy on water defences and the resulting coastal and hydraulic engineering design codes (technical documents) are briefly overviewed. Special attention is paid to organizational...
Study of Three Dimensional Crack Tip Location of Mortar by Acoustic Emission
Plain mortar specimens were tested under three-point bending. Experimental variables include the width of the specimen and the notch-to-depth ratio. The experimental results of 12 specimens...
Concrete Beam Testing with Optical Fiber Sensors
The use of an embedded multimode optical fiber to monitor curing and load-to-failure testing of a reinforced concrete beam has been investigated. The embedding process used to network...
Nondestructive and Destructive Testing of a Three Span Skewed R. C. Slab Bridge
A three span, skewed, reinforced concrete slab bridge was field tested to destruction by the authors. Before the actual destructive test, nondestructive tests were performed to determine...
On the Influence of Seismically Induced Residual Forces on Bridge Abutment Design
The seismic design of bridge abutments depend on the anticipated movement of the abutment during the design earthquake. For seat-type abutments in which the backfill resistance can be...
Damage Dependent Micromechanics in Metal Matrix Composites
A computational approach is used herein to model the effects of processing induced thermal residual stresses on radial, hoop, and shear stresses at the fiber/matrix interface in a continuous...
Constitutive Modeling and Simulation of Energy Absorbing Polyurethane Foam Under Impact Loading
The compressive-stress strain response of polyurethane foam under uniaxial compressive impact loading has been studied. The development of a uniaxial constitutive model from strain rate...
On the Diffusional Stress Transmission
A probabilistic diffusional mechanism for the propagation of intergranular forces has been formulated as a set of three mathematical assumptions. The equilibrium equations are complemented...
The Control of Large Amplitude Liquid Sloshing with Moving Baffles
Numerical simulations of three-dimensional viscous liquid sloshing in rectangular containers were carried out using an improved volume of fluid technique in conjunction with the Navier-Stokes...
Comparative Evaluation of Plasticity Theories Against Tension-Torsion Test at Finite Strain
This paper investigates and evaluates three hardening theories against a variety of nonproportional loading experiments on tubes made of annealed copper. It was concluded that the isotropic...
Refined Analysis of Load Distribution Factors for Bridges
This paper presents a new approach for calculating the distribution factors for slab-on-girder bridges. This method considers the coupling of longitudinal and transverse effects. The governing...
Size, Temperature and Rate Effects on the Fracture Toughness of Saline Ice
This paper presents the results of an extensive experimental study performed with the aim of investigating the effects of temperature, size and loading rate on the fracture toughness of...
Return to search