Deadly Debris Flows on I-5 Near Grapevine, CA
A series of debris flows inundated the southbound lanes of interstate Highway 5 (1-5) approximately 110 km (70 mi) NW of Los Angeles, California, between Fort Tejon and Grapevine, early...
Rheological Properties of Simulated Debris Flows in the Laboratory Environment
Steady debris flows with or without a snout are simulated in a 'conveyor-belt' flume using dry glass spheres of a uniform size, 5 or 14 mm in diameter, and their...
Rheological Analysis of Fine-Grained Natural Debris-Flow Material
Experiments were conducted on large samples of fine-grained material (?2mm) from a natural debris flow using a wide-gap concentric-cylinder viscometer. The rheological behavior of this...
The Bearing Capacity of Debris Flows
Debris flows are made of a cohesive muddy matrix in which large and heavy particles exist in suspension. To explain how these particles are maintained in suspension, several mechanisms...
Flume Experiments on Debris Flow
With the different characteristics of grain motion in debris flow, three layers are vertically divided, i.e., viscous collision layer, inertial collision layer and suspension layer. Both...
Experimental Study on the Rheologic Behavior of the Slurry of Viscous Debris Flow
The slurry of viscous debris flow is a kind of dense solid-liquid mixture. It has very complicated rheologic behavior. As shown in the experiment described in this paper, the slurry exhibits...
Experimental Study on the Flow Properties of Debris Flow
A new flow property model for viscous debris flow was presented in this paper. The results of the flow property model were in good agreement with the results of specific experiments. The...
Two-Dimensional Modeling of Overland Flow
Two-dimensional distributed finite element (F-E) and finite difference (F-D) models are developed to simulate storm events on arid watersheds. The F-E model uses the kinematic wave approximation,...
Two-Dimensional Modeling of Alluvial Fan Flows
A two-dimensional, flood routing model FLO-2D has been developed to route water and mudflows over unconfined surfaces. It predicts flow velocities and depths at discrete points for channel...
Application of the U.S.G.S. DHM for Floodplain Analysis
The two-dimensional Diffusion Hydrodynamic Model, DHM, is applied to the evaluation of floodplain depths resulting from an overflow of a leveed river. The environmental concerns of flood...
Phoenix Flood Hydrology for Price Expressway
Recently HDR Engineering, Inc. (HDR) completed a study of the off-site stormwater volumes and peak flow rates for the Price Expressway and Santan Freeway in suburban Phoenix. HDR is the...
Management Strategies for Baseflow Augmentation
Management strategies for baseflow augmentation fall into the following categories: (1) livestock management, (2) upland vegetation management, (3) riparian vegetation management, (4)...
Unsteady Flow of Bingham Viscoplastic Material in an Open Channel
An analytic solution for transient flow of a Bingham viscoplastic material in an open channel is presented. The solution for the response to a time-varying pressure gradient predicts shear...
Waves in a Fluid Mud Layer Flowing Down an Incline
To model the dynamics of fluid mud, lava, or debris with a high concentration of cohesive clay particles, we consider a thin sheet of Bingham plastic fluid flowing down a slope. The Bingham...
Field Observation of Roll-waves in Debris Flow
In 1979, the observatory of debris flow was set up in the Hase River of Mt. Sakurajima in Japan which is one of the most active volcanoes in the world. Obvious roll-waves on each debris...
Some Aspects of the Mechanism of Debris Flow
As the first step of the development of a general two-phase flow model for debris flows, a simple granular model, which is considered as a special case of the two-phase flow model, is...
Predicting Stream Width and Bank Retreat
The width of streams is dependent on the flood flow discharge which varies from year to year, the bank material which varies from stream to stream and reach to reach, the sediment load...
Longitudinal Surface Profiles of Granular Debris Flows
Longitudinal surface profiles of granular material flowing down an inclined plane were studied by means of theoretical analysis and laboratory experiments. There are two driving forces...
Model of Deposition of Grains from Debris Flow
Rapid deposition of grains from debris flow occurs in a channel whose slope angle decreases abruptly. A model of the deposition is presented on the basis of experiments and theoretical...
Multiple Phenomena of Debris-Flow Processes: A Challenge for Hazard Assessments
Hazardous hydraulic processes associated with arid environments commonly repesent significant risks to the safety of the public. However, the public generally considers these risks to...
Return to search