Acceleration
This chapter discusses basic principles of acceleration, gravity, and thrust for reference....
Space Truss
The International Space Station will be more than 310 ft (94 m) long when it is completed sometime in the next decade. The backbone of the structure is a hexagonal truss system that will...
Avoiding Common Thrust Restraint Mistakes
Feds' New Thrust Is Waste Containment
Evaluation of Active Thrust on Retaining Walls Using DDA
Propulsion Systems for Future Space Exploration
There are many types of propulsion that are being considered for future space travel needs. These include nuclear, solar sail, magnetoplasmadynamic (MPD) thrusters, and laser propulsion...
Computer Calculations Speed Tunnel-Lining Design
A computer program handles the computations and simplifies a method that sets forth the vast amounts of tunnel concrete lining design information in a single diagram. Using the principle...
Structural Analysis for the Student
The transition from student to practicing structural engineer can be a very 'eye-opening' experience. From the classical right-wrong classroom solutions of well-defined indeterminate structures,...
Numerical and Centrifuge Modeling of an Arch Dam on Jointed Rock
This paper addresses the stability of an arch dam built on highly fractured argillite. A large concrete thrust block combined with a wing dam forms the left dam abutment. The last FERC...
Spring-Type Thrust Bearings Can Be Monitored
Infratechnologies: Tools For Innovation
Infratechnologies support the practices of construction over the whole life cycle of constructed facilities. They include technologies for developing and applying information, standards,...
Developing Technologies for Lunar-Based Astronomy
The Moon is probably the best place in the inner solar system to locate a new generation of astronomical observatories. The thrust of space program planning is toward a return to the Moon...
Shaft Boring Machine?A Method of Mechanized Vertical Shaft Excavation
The Shaft Boring Machine (SBM) is a vertical application of proven rock boring technology. The machine applies a rotating cutter wheel with disk cutters for shaft excavation. The wheel...
Some Unusual Vibrations in Hydro Machinery
Most hydro machinery engineers have read the textbook cases of self-exited and flow induced vibrations. Usually such textbook vibrations are only found in the text book! In the real world,...
Post-MECO Propulsion System Requirements for Placement of an STS External Tank in Low Earth Orbit
This paper discusses the findings of a series of computer simulations carried out at the National Institute of Standards and Technology to investigate the requirements for powered flight...
Trouble-Shooting Large Hydroturbine Bearings
Special problems associated with very large thrust and guide bearings and lubrication systems are presented, and cover common trouble spots, with examples. Various large hydroturbine bearing...
Influence of Surface Finish on Thrust Bearing Life
The original pivoted pad thrust bearing installed and fitted at the Holtwood Power Station in 1912 by A. Kingsbury has been operating continuously since that time without any difficulty....
Fretting Corrosion on Large Split Thrust Bearing Runners
In the early fifties interfacial slip was measured on laboratory models. Design improvements, resulting from these tests, were incorporated into later machines. These improvements appreciably...
The Use of Restrained Joint Ductile Iron Pipe
This paper addresses some of the problems we at U. S. Pipe have observed from restrained joint installations during the past several years and the solutions devised. The restrained joints...
Thrust Restraint of Buried Ductile Iron Pipe
It is the intent of this paper to present current state of the art thrust restraint design, present a basis for calculating required lengths of restraint, and to offer some practical suggestions...
Return to search