Innovations in Geosynthetic Rolled Erosion Control Products: From Forests to Fibers
Over the last 50 years, many different types of geosynthetic rolled erosion control products (RECPs) have emerged, ranging from different structure types to different fiber types. Natural-fiber...
Dynamic Shearing Properties Of Compacted Clay
A series of 116 Q-type triaxial compression tests was performed using specimens of Goose Lake clay compacted at water contents ranging from 9 percent dry of optimum to 3 percent on the...
Shear and Interface Strength of Clay at Very Low Effective Stress
Thin-specimen direct shear (TSDS) tests were conducted to measure the shearing strength of kaolinite, and interface strengths between kaolinite and acrylic plastic and anodized aluminum,...
Application of Model Pile Tests to Axial Pile Design
Experiments conducted with instrumented model pile segment probes at Harvey and Empire, Louisiana are summarized and the observed behavior interpreted. Correlations are developed for the...
Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years: Volume Five
Prepared by the Program Committee, Offshore Technology Conference, of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...
Chemical Grouting
Chemical grouting is used in underground construction primarily on soft-ground shafts and tunnels in an effort to control cohesionless or running ground conditions by modifying the soil....
Size and Scale Effects on the Shear Strength of Concrete Beams
This paper identifies and discusses the role of proper geometric scale of relevant parameters in the size effect in shear, particularly in terms of practical beam design. In the overall...
Direct Causes of the Catastrophe
This chapter examines direct physical causes of the hurricane protection system failures, including soil strength assessments and pumping station limitations....
Structural Condition Assessment
In Structural Condition Assessment, editor-in-chief Robert Ratay gathers together the leading people in the field to produce the first unified resource on all aspects of structural condition...
Concrete Biaxial Column: Introduction
This chapter introduces the subject of concrete biaxial columns....
Concrete Biaxial Column: Composite Circular Column
This chapter discusses the tabulation of composite circular column data in Microsoft Excel....
Concrete Biaxial Column: Partial Shell
This chapter discusses the tabulation of partial shell data in Microsoft Excel....
Concrete Biaxial Column: Photographs
This chapter includes photographs of concrete biaxial columns....
Embed
This chapter discusses the tabulation of tension, compression, and flexural development data in Microsoft Excel....
LRFD Compared to Working Strength Loads: Introduction
This chapter introduces the subject of load resistance factor design as compared to working strength loads....
LRFD Compared to Working Strength Loads
This chapter contains examples used to demonstrate the design of footings to resist seismic loads....
Strength Design in Aluminum
A Review of Three Codes
Prepared by the Task Committee on Strength Design in Aluminum of the Committee on Special Structures of the Committee on Metals of the Structural Engineering Institute of ASCE. ...
New Shear Stud Provisions for Composite Beam Design
The 2005 American Institute of Steel Construction (AISC) Specification for Structural Steel Buildings (AISC 2005) will contain significant changes to the shear connector provisions for...
A More Perfect Union
Established to promote greater public understanding of the United States Constitution, the National Constitution Center facility in Philadelphia is a structure of complex geometries articulated...
Flexural Behavior of Slender Post-Tensioned Masonry Walls
The 2002 edition of the Masonry Standards Joint Committee (MSJC, 2002) design provisions for masonry structures includes a chapter on the design of post-tensioned masonry (PTM) walls with...
Return to search