Evaluation of Rehabilitation Needs for Hydraulic-Fill Dam
This paper describes the application of analytical methodologies developed for seismic stability analysis of dams in the western U.S. (particularly the Lower San Fernando Dam in Southern...
Shear Connection in Composite Beams
This paper considers the influence of the shape of the deck profile on the shear connection of composite beams. It was found that the existing strength reduction factor can be unconservative...
Perfobond Rib Connectors for Composite Beams
In this paper, the influence of concrete strength, transverse reinforcement and concrete dowels on the capacity of perfobond rib shear connectors is examined. Perfobond rib connector is...
Design of Composite Slabs for Vertical Shear
Three major modes of failure should be considered in the design of the positive moment regions of composite slabs incorporating profiled steel sheeting, viz.: flexure, longitudinal slip...
Development of Composite Slab with Truss-Typed Shear Connectors
This paper describes the results of the test on a steel-concrete composite slab with truss-typed shear connectors. This composite slab was recently developed. A series of tests were conducted...
Use of the Break-Off Method for the Evaluation of High Performance Concrete
The Break-Off test is one of the recent developments for testing in-place concrete strength. This research was undertaken to investigate the reliability of the Break-Off test as a measure...
Application of SMA Technology in Georgia
In 1991, the Georgia Department of Transportation participated in a cooperative effort with the Federal Highway Administration to conduct one of a series of field evaluations of Stone...
A Laboratory Investigation on Long-Term Performance of Asphalt Concrete Treated with Antistripping Additives
Asphalt concrete pavement is susceptible to moisture damage and the damage caused by repeated freeze-thaw cycles is a major problem. This paper summarizes a laboratory investigation for...
Realistic Specifications for Manufactured Sand
Data which demonstrate the beneficial effect of using fine aggregate having high fines contents on concrete properties are presented. All data indicate that the use of a high fines content...
High Strength, Low Permeability Garage Rehab Concrete
Physical and engineering properties of high strength structural lightweight concrete used to replace deteriorated concrete in garage structure rehabilitation programs are reported. Structurally...
Concreting at Subfreezing Temperatures
Temperature affects the rate at which portland cement concrete develops strength. Below about 20°C, strength gain is retarded, whereas at higher temperatures it is accelerated. Strength...
Implementation of Material Requirements in Specifications
This paper focuses on where to find information on materials, their compatibility, minimum standards and specifying of materials and their use. The paper also presents case histories on...
Bond Strength of Straight GFRP Rebars
An overview of a study on bond of straight Glass-fiber-reinforced-plastic (GFRP) rebars to concrete is presented. The 54 specimens to be tested include several variables, such as the mode...
Behavior of Externally Confined Concrete Columns
This paper investigates the feasibility of strengthening of seismically deficient concrete columns with high-strength fiber composite straps. The concrete columns will be externally confined...
Fiber/Epoxy Composites Strengthen Bridge Columns
The California Department of Transportation is using high strength fiber/epoxy composites to strengthen existing reinforced concrete bridge columns. These advanced composite materials...
Stability and Performance of Slopes and Embankments II
This proceedings,
Problems Related to Disposal of Fly Ash and its Utilization as a Structural Fill
Utilization of Fly Ash in High Volumes for Low Strength Cement Composites
Performance of Crushed Waste Concrete as Aggregate in Structural Concrete
Cyclic Behavior of a Deepwater Normally Consolidated Clay
A comprehensive advanced laboratory testing program was undertaken to study the cyclic behavior of clays under various combinations of one-way and two-way cyclic loading. This work was...
Return to search