Life-Cycle Design, Assessment, and Maintenance of Structures and Infrastructure Systems
Prepared on behalf of the Task Group 1 on Life-Cycle Performance of Structural Systems Under Uncertainty of the Technical Council on Life-Cycle Performance, Safety, Reliability and Risk of Structural Systems...

California Ruling Expands Liability of Site-Safety Consultants
This month's column features Peredia v. HR Mobile Services Inc.—a recent appellate decision that offers a thorough analysis of jobsite safety liability for consultants....

Reviewing the Civil Engineer's Ethical Obligations at Home and Abroad (Part 2)
This month's column is a continuation of last month's in which various international codes of conduct for engineers were compared to ASCE's....

Discouraging Women from STEM Careers Would Violate ASCE's Code of Ethics
The chief executive of a national engineering society writes a column that discouraging women from pursuing career in the science, technology, engineering, and mathematics (STEM) fields. If he has had...

Double Duty
On June 8, 2018, more than 100 years after its namesake was born in the Little Harbor neighborhood of Portsmouth, New Hampshire, residents and dignitaries from New Hampshire and Maine gathered to celebrate...

A Different Angle (part of "West Side Extraordinary")
The unique, sloping shape of the VIA 57 West building is formed from cast-in-place concrete from the single, partial basement level up to the structure's 34th floor; braced galvanized steel framing completes...

When Old Meets New: Railway Geotechnics and Remote Sensing
Railroad track, like any other built structure, relies on a foundation of geomaterials for support. In its most basal form, the railway track is quite simple: steel load-bearing members (rails) supported...

The Leaning Towers of Wilmington, Delaware: Emergency Response and Retrofit of the I-495 Viaduct to Address Lateral Squeeze
On a sunny, summer afternoon last June, the project manager for AECOM's open-end bridge design contract with the Delaware Department of Transportation (DelDOT) received an...

General
Design of Latticed Steel Transmission Structures specifies requirements for the design, fabrication, and testing of members and connections for electrical transmission structures. These...

Loading, Geometry, and Analysis
This Standard applies to latticed steel transmission structures. These structures shall be either self-supporting or guyed. They consist of hot-rolled or cold-formed prismatic members...

Structural Members and Connections Used in Foundations
This chapter specifies design procedures for steel members and connections embedded in concrete foundations or the earth. Additional design requirements for structural members and connections...

Axial Load Capacity of Pipe Piles in Sands
The axial load capacity of driven, open-ended, steel pipe piles in cohesionless soils, is often estimated using a method such as the American Petroleum Institute Recommended Practice 2A...

Behaviour of Open-Ended Pipe Piles in Sand During Installation and Loading
An experimental study was performed to investigate the physical processes which influence the axial load capacities of open-ended steel pipe piles in sand. A double-walled pipe pile was...

Axial Capacity of Steel Pipe Piles in Clay
Development of theories for the prediction of the axial compressive and tensile load capacities of driven piles is made difficult by a variety of factors, e.g., disturbance of the soil...

Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years
Prepared by the Program Committee of the Offshore Technology Conference of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...

Offshore Platform Steel Specification
The discovery in the 1980's of local brittle zones (LBZ's) in and near the heat-affected zone (HAZ) of the fabrication welds in certain offshore platform steels...

Design and Installation of Auger Steel Catenary Risers
The Auger export pipelines are connected to the TLP by steel catenary risers (SCRs). This is believed to be the first time steel pipe has been used for catenary risers. SCRs offer advantages...

Cyclic Response of Steel-Stud Framed Wall Panels

Seismic Behavior of Tubular Steel Offshore Platforms

Alternative Hybrid Wall Systems
This chapter discusses alternative hybrid wall systems. Topics include unbonded post-tensioned coupled wall systems; steel coupling beam with fuse; and composite shear plate coupling beam....

 

 

 

 

Return to search