Ductility and Failure Modes of Single Reinforced Concrete Columns
Ulitmate Behavior of R/C Bearing Walls: Experiment and Modeling
Behavior of Cyclically Loaded Shear Walls
Lateral Loading & Seismic Response of CIDH Pile Supported Bridge Structures
Evaluating Axial Drilled Shaft Response by Seismic Cone
Liquefaction Mitigation at JFK Airport Using Dynamic Compaction
Modeling of Inelastic Behavior of RC Structures under Seismic Loads
Proceedings of the U.S.–Japan Seminar on Post-Peak Behavior of Reinforced Concrete Structures Subjected to Seismic Loads: Recent Advances and Challenges on Analysis and Design, held in...
Seismic Design of Highway Bridges: Recommended Specifications
Under the AASHTO-sponsored National Cooperative Highway Research Program (NCHRP), a joint venture of the Applied Technology Council and the Multidisciplinary Center for Earthquake Engineering...
A Framework for Performance-Based Seismic Design
The following probabilistic framework for seismic performance assessment is presented as an effective foundation for the development of performance-based guidelines. It suggests a generic...
Effect of Column-to-Beam Strength Ratio on Seismic Performance of RC Moment Frames
Reinforced concrete (RC) moment frames are often used in building applications. During strong earthquake excitations, such buildings have been subject to soft-story or column sidesway...
Fragility Curves and Seismic Loss Estimation Methodologies Based on Insurance Data
Loss data for single family dwellings from the 1994 Northridge, California, earthquake were correlated with ground motion with the aim of determining ground motion-based fragility curves....
New Developments in the Field of Seismic Isolation
This paper will concentrate onwhat likely, is the most significant of these issues: changes in the mechanical properties ofseismic isolation and energy dissipation hardware as they are...
Performance of Masonry in Disasters: Lessons Learned and Research Needs Identified
This presentation described in this extended abstract is one of several in a panel discussion entitled Enhanced Research in Masonry. The objectives of the presentation are to discuss the...
Seismic Analysis and Retrofit of the Amoskeag Bridges
In 1983 AASHTO first offered the design guide for seismic analysis of bridges, which ultimately became a permanent part of the AASHTO Bridge Design Manual in 1990. Prior to this time,...
Evaluation Findings for Seismic Energy Products, L.P. Elastromeric Isolation Bearing
Prepared by the Highway Innovative Technology Evaluation Center (HITEC), a CERF Service Center. This report presents the results of a detailed evaluation...
Dynamic Response of Lattice Towers and Guyed Masts
Prepared by the Task Committee on the Dynamic Response of Lattice Towers of the Technical Committee on Special Structures and the Technical Administrative Committee on Metals of the Structural...
Finite Element Analysis of Reinforced Concrete in Bridge Seismic Design Practice
A Full-Scale Seismic Testing Center for Soils and Structures
Moment Resisting Steel Frames—Background to Present Problems
A Comparison of Two Three-Dimensional Shallow-Water Models Using Sigma-Coordinates and z-Coordinates in the Vertical Direction
Return to search