A New Approach to Mitigate Subsidence Problems: A New Approach to Mitigate Subsidence Problems
Mexico City has a decades-old problem with severe consequences: its lacustrine zone is subsiding due to pumping of potable water from the main aquifer. The geotechnical team assigned to work on the problem...
Connecting Continents: Challenges of the Eurasia Tunnel in Istanbul
The Eurasia Tunnel, the first bored tunnel crossing of the Istanbul Strait (Bosphorus) in Istanbul, Turkey, is a site that presents many unique challenges, including very poor ground conditions, unusually...
Improving Cost and Schedule Performance on Municipal Pipeline Projects: Realizing the Benefits of the Construction Manager at Risk (CMAR) Alternative Project Delivery Method
The water and wastewater infrastructure in the United States is failing. In its 2013
Review of Climate Science for Engineering Practice
Weather and climate are a factor in civil engineering design and practice. Weather is defined as the state of the atmosphere with respect to wind, temperature, cloudiness, moisture, pressure,...
Project Layout
Microtunneling projects should be laid out with attention to the benefits and constraints unique to this construction process. The following recommendations address some of these concerns:...
Pipe Characteristics
Microtunneling pipe should meet the following general requirements: Circular shape with a flush outside surface (including at the joints); Strength sufficient to withstand both the installation...
Pipe Design
The pipes and joints, once installed, must be capable of safely withstanding, for the project design life, all in-use service loads, including those associated with the following factors:...
Field Aspects
As soon as practical after their arrival at the project site, all pipes, fittings, and appurtenances should be thoroughly checked for compliance with the contract documents and accepted...
Shafts/Temporary Structures
Shafts should be of a size to accommodate the equipment and pipe selected and to allow for safe working practices. If the shaft must accommodate the permanent works, it is the contractor's...
Performance Limits for Deepwater Pipelines
This paper highlights the differences between onshore and offshore pipeline design. It then summarizes the results of combined external pressure, tension, and bending testing on full scale...
Estimation of Consolidation Properties of Clay from Field Observations
Analyses to obtain theoretical time-settlement curves for embankments typically make use of soil properties measured in the laboratory on small disturbed samples subject to strain rates...
Axial Load Capacity of Pipe Piles in Sands
The axial load capacity of driven, open-ended, steel pipe piles in cohesionless soils, is often estimated using a method such as the American Petroleum Institute Recommended Practice 2A...
Behaviour of Open-Ended Pipe Piles in Sand During Installation and Loading
An experimental study was performed to investigate the physical processes which influence the axial load capacities of open-ended steel pipe piles in sand. A double-walled pipe pile was...
Pore Water Pressures in Unsaturated Soils
Unsaturated soils are three-phase systems composed of solid mineral matter, water, and air. Such soils may be formed by either natural or artificial means. Except in moist environments,...
Axial Capacity of Steel Pipe Piles in Clay
Development of theories for the prediction of the axial compressive and tensile load capacities of driven piles is made difficult by a variety of factors, e.g., disturbance of the soil...
Design and Installation of Auger Steel Catenary Risers
The Auger export pipelines are connected to the TLP by steel catenary risers (SCRs). This is believed to be the first time steel pipe has been used for catenary risers. SCRs offer advantages...
Enhanced Detection and Mapping of Buried Utilities—A Sustainability Perspective
The social and environmental impacts and benefits of projects make up the triple bottom line that represents a modern view of sustainable project development. Rather than considering only...
The Measurement of Wave Heights by Means of a Float in an Open-End Pipe
Water Gravity Waves Generated by a Moving Low Pressure Area
Fast-Track Repairs of Critical Levee Erosion Sites
Return to search