Characteristics of Flow Pressure Pulsation and Similitude Law of Model
As described in this paper, the characteristics of flow pressure pulsation and similitude law of model are derived from experiments on some prototype dam and serial scales models....
Selection of Hole Size for Fluidization Pipes
Two-dimensional fluidization experiments are performed on fine and medium coarse quartz sands at depths of 25.4 and 42 cm. Four supply pipes are used with orifice diameters of 1.587 mm...
A Microplane Constitutive Model for Soils
A microplane model for the inelastic behavior of soils is presented. The microscopic constitutive equations are defined independentely for a set of microplanes covering all possible orientations,...
Performance of Large Gravity Walls at Eisenhower and Snell Locks
Estimating Lateral Earth Pressures for Design of Excavation Support
Subway Design and Construction for the Downtown Seattle Transit Project
Design of Ductile Iron Pipe on Supports
Design procedures for ductile iron pipe in normal underground service have been well established. The standard design considers hoop stresses in the pipe wall due to internal hydrostatic...
Column Separation in Pumped Pipelines
Pressure transients are common occurrences in water supply systems. Pipeline standards and design/testing techniques will normally provide sufficient protection for transmission and distribution...
Steel Girt Design
Procedures are presented for the design of light gage cold formed girts and hot rolled girts. The effects of continuity, sag rods, and wall sheeting are discussed. Design procedures are...
Local Wind Pressures on Roofs
The paper reviews the results of the most recent research studies in the evaluation of wind pressure coefficients for the design of roof cladding elements. The effect of roof geometry...
Wind Effects on Loose-Laid Cladding Systems
Modern roofing systems for flat roofs frequently make use of rigid insulation boards, gravel and concrete pavers that are loose-laid on top of the waterproof membrane. The authors have...
Full-Scale Measurement on Chiba Port Tower
Chiba Port Tower is a tall tower, 125m high, with a rhombus shaped plan. All of the surfaces are covered with half mirror glass. On the top of the tower, a 'Tuned Mass Damper'...
Vibration-Induced Wind Pressure on Large Span Flat Roof
Vibration-induced wind pressures on a large span flat roof was investigated by a wind tunnel using a uniformly turbulent flow. Measurements of pressures were made on an asymmetrically...
A New Proposal of Design Wind Loads for Beams Supporting Long-Span Roofs
The wind tunnel testings of wind pressures acting on long-span roofs are carried out. Dynamic wind pressures are measured simultaneously at a lot of points on the roofs. The instantaneous...
Pressure Measuring System for Wind Loads
A project to acquire wind and building surface pressure data in the field is continuing at Texas Tech University. A test building of dimensions 30 × 45 × 13 ft (9.1 × 13.7 × 4.0 m) and...
Hydrodynamic Isolation of Concrete Dams
The feasibility of reducing hydrodynamic effects in the earthquake response of concrete dams by anchoring gas-filled balloons or injecting bubbles in the water is investigated. Significant...
Preventative Debris Flow Mitigation
Site Characterization of Yorktown Formation for New Accelerator
The design of a new 1700-m long continuous-wave electron beam accelerator facility (CEBAF) in Newport News, Virginia demanded an extensive geotechnical exploration program be conducted...
Pressuremeter Evaluation of Glacial Till Bearing Capacity in Toronto Canada
Glacial tills were evaluated at three Toronto sites, using conventional methods, the pressuremeter and full scale caisson load tests. The geologic environment and specific subsurface conditions...
Screw Plate Test for Drained and Undrained Soil Parameters
This paper describes a screw plate test device developed with a capability to measure the generation and dissipation of excess pore water pressure during testing in cohesive soils. The...
Return to search