An Aggressive I/I Abatement Program is Underway as Part of Vallejos Wet Weather Program
The Vallejo Sanitation and Flood Control District (VSFCD) is undertaking an aggressive pilot program to control wet weather flows and eliminate sanitary sewer overflows (SSOs) that are...
Book Review:
Book Review:
Evaluation of the CON/SPAN Wingwall System
This evaluation was performed on CON/SPAN Wingwalls, precast concrete end walls for the CON/SPAN Bridge System developed, designed, and supplied by CON/SPAN Bridge System, Inc....
Shotcrete Lining Design Concepts for New and Rehabilitated Tunnels
FEM Analysis for Structural Performance Design of Concrete Structures
Ductility and Failure Modes of Single Reinforced Concrete Columns
Liquefaction Mitigation at JFK Airport Using Dynamic Compaction
Modeling of Inelastic Behavior of RC Structures under Seismic Loads
Proceedings of the U.S.–Japan Seminar on Post-Peak Behavior of Reinforced Concrete Structures Subjected to Seismic Loads: Recent Advances and Challenges on Analysis and Design, held in...
Seismic Design of Highway Bridges: Recommended Specifications
Under the AASHTO-sponsored National Cooperative Highway Research Program (NCHRP), a joint venture of the Applied Technology Council and the Multidisciplinary Center for Earthquake Engineering...
A Framework for Performance-Based Seismic Design
The following probabilistic framework for seismic performance assessment is presented as an effective foundation for the development of performance-based guidelines. It suggests a generic...
New Developments in the Field of Seismic Isolation
This paper will concentrate onwhat likely, is the most significant of these issues: changes in the mechanical properties ofseismic isolation and energy dissipation hardware as they are...
Update of Serviceability Design Considerations for Low-Rise Steel Buildings
In 1990, the American Institute of Steel Construction published Servicability Design Considerations for Low-Rise Buildings by James M. Fisher and Michael A. West. This document was published...
Seismic Analysis and Retrofit of the Amoskeag Bridges
In 1983 AASHTO first offered the design guide for seismic analysis of bridges, which ultimately became a permanent part of the AASHTO Bridge Design Manual in 1990. Prior to this time,...
Evolution of Composite Floor Systems in the United States
Composite floor systems, which combine structural steel beams with a cast-in-place concrete slab, have grown in popularity in the U.S. during the past 40 years. In most early applications,...
Development and Validation of Mechanistic Coefficients for Flexible Pavement Structures Designed by AASHTO Guide
Evaluation Findings for Seismic Energy Products, L.P. Elastromeric Isolation Bearing
Prepared by the Highway Innovative Technology Evaluation Center (HITEC), a CERF Service Center. This report presents the results of a detailed evaluation...
Evaluation of Thermocoax Piezoelectric Weight-in-Motion Sensors
Prepared by the Highway Innovative Technology Evaluation Center (HITEC), a CERF Innovation Center. This report describes a program of installation,...
Evaluation of Measurement Specialties, Inc. Piezoelectric Weigh-In-Motion Sensors
Prepared by the Highway Innovative Technology Evaluation Center (HITEC), a CERF Innovation Center. This report describes a program of installation,...
Revised Operation of a Dam and Reservoir to Achieve Environmental Objectives
Alamo Dam and Lake are located in the State of Arizona in the western part of the United States of America. The dam is located 62.8 km (39 mi) upstream (east) from the rivers confluence...
Return to search