Mechanisms of Subsidence Induced Damage and Techniques for Analysis
Structural damage due to mining induced subsidence is a function of the nature of the structure and its position on the subsidence profile. A point on the profile may be in the tensile...

Long-Term Stabilization Considerations for Decommissioned and Reclaimed Uranium Sites

Subsidence Control by High Volume Grouting
Mine grouting programs generally fall into two general methods: flushing and grout columns. With the flushing method, the entire mine under the area to be protected is filled. Grout columns...

Integrated Coal Gasification Wastewater Treatment

Pragmatic Approaches to the Clean-Up of Coal Tar Sites

Burnout Control of Waste Coal Piles

Role of Waste Culm in Cogeneration

Dispersion of Coal Particles at the Sea Floor
Due to coal unloading, certain quantities of this material arrive at the sea floor, and may pollute the beaches. This study provides a theoretical analysis and numerical simulations of...

Erosion of the Slopes of Gold Tailings Dams
A study has been made of rates of erosion from the slopes of gold-residue dams in the South African Highveld region. Data is available for two years at this time and conclusions must therefore...

Use of Geomembranes in Deep Valley Landfills
The installation of geomembranes (synthetic liners) under deep valley landfills of utility and mine waste presents unique problems. Limited data are available concerning geomembranes beneath...

Environmental Geotechnology & Tailings Reclamation
The Department of Energy is responsible, in terms of Federal Legislation, for remedial action work at 24 inactive uranium mill tailings piles in ten states. This paper describes the setting...

Reclamation of Athabasca Oil Sand Sludge
The bulk of oil sand tailings (80 to 90%) consists of quartz sand, which is defined to be everything coarser than 44 microns. The other 10 to 20%, termed 'sludge',...

Biological Treatability of In-Situ Coal Gasification Wastewater

Thickened Slurry Disposal Method for Process Tailings
Common practice in the disposal of process tailings consists of impounding the wastes as thin slurries or suspensions in diked containment areas. Such a procedure poses problems relating...

The Typical Engineering Properties of Fly Ash
Knowledge of key physical and engineering properties of coal fly ash is needed in the planning, design, and construction of both disposal and utilization projects. While considerable data...

Territorial Sea Management by the State of Oregon
The institutional capability of the State of Oregon to manage the territorial sea under its jurisdiction recently was examined by the authors. Oil and gas development, marine mineral mining,...

Coal Mining in Alaska's Interior: Problems and Solutions
The Usibelli Coal Mine located in Healy, Alaska is currently the largest operating coal mine in the state of Alaska. The mine has recently increased production to nearly 1. 7 million tons...

Geotechnical investigation: Cominco's Red Dog Mine Facilities
The siting of major facilities associated with development of the Red Dog Mine Complex in Northwestern Alaska on relatively warm permafrost soil and rock presented geotechnical engineers...

Predicting Head Loss for Chunk Coal Slurry Transport

Liquefaction Study of Coal Refuse by Nuclear Gauges
This paper presents a technique for utilizing nuclear gauges to determine density and moisture content continuously throughout refuse embankments and slurry reservoirs. The nuclear measurements...

 

 

 

 

Return to search