Application of EPS for Slide Correction
Two New Specialty Geotechnical Processes for Slope Stabilization
Use of a Tie-Back Retaining Wall to Stabilize a Moving Landslide
After failure of a gravity retaining wall, a moving landslide was stopped and stabilized by a tie-back retaining wall. The design considered the active landslide and residual strength...
A Data Acquisition System for Defining Geologic Structure and Site Characterization
The Impact of the October 17, 1989 Loma Prieta Earthquake on Coastal Bluffs and Implications for Land Use Planning
The October 17, 1989, Loma Prieta earthquake caused bluff failure along 100 miles of coastline between San Francisco and central Monterey Bay in a variety of rock types and slope conditions....
Sea-Cliff Erosion Along the Oregon Coast
Sea-cliff erosion is a problem along the coast of Oregon in that many communities have been built on terraces affected by bluff retreat. There is considerable coast-wide variability in...
Screening Data with an Expert System (PDAS)
The performance of a three-mile long penstock, constructed in an active landslide area in northern California, is monitored using 138 vibrating wire-strain gauges. Readings are taken daily,...
Design of Penstocks in Severe Earth Slide Locations
This paper deals with the problems of locating a penstock for a small hydroelectric plant at a site in Northern California that experiences considerable land movement during the rainy...
Penstock Monitoring System in Active Landslide Areas
During initial planning of a high-head, five megawatt hydroelectric plant in Northern California, it was identified that the entire three-mile length of a 40 inches welded steel penstock...
Numerical Methods for Simulating Debris Blockage Failures and Mudflows
This paper presents the procedures and results from an investigation to evaluate the hydraulic characteristics of mudflow events resulting from hypothetical failures of a debris blockage...
Response of Sliding Base-Isolated Structures
Experimental and anlaytical results on the behavior of sliding isolated structures are presented. A mathematical model of friction of Teflon bearings is developed, calibrated, and verified....
Restoration of a Buttress Dam
Inspections of Morris Shepard Dam on the Brazos River in Texas revealed serious defects in the dam and its foundation. Piezometric pressures below the spillway buttresses greatly exceeded...
Landslides and Cherry Trees -- Upgrading the Dalles Irrigation District
The Dalles Irrigation District recently began the process of applying for a federal loan to finance upgrading of the District's distribution system. The process included preparation...
Deadly Debris Flows on I-5 Near Grapevine, CA
A series of debris flows inundated the southbound lanes of interstate Highway 5 (1-5) approximately 110 km (70 mi) NW of Los Angeles, California, between Fort Tejon and Grapevine, early...
Mudflow Rheology in a Vertically Rotating Flume
Joint research by the U.S. Geological Survey and the University of Missouri-Rolla currently (1990) is being conducted on a 3.05 meters in diameter vertically rotating flume used to simulate...
Numerical Simulation of Mudflows from the Hypothetical Failure of a Debris Blockage Lake Below Mount St. Helens, WA
This paper evaluates the characteristics of mudflow events resulting from the hypothetical breaching of a debris blockage dam using a variety of lake levels and impounded water volumes...
Design of a Lined Landfill on Compressible Clays
In mid-August, 1989, a 500,000m3 landslide occurred at a commercially operated landfill in central Maine. The landslide material consisted of municipal...
Inelastic Response of Buried Pipelines Due to Landslide Effects
During earthquakes, a buried pipeline may experience significant loading as a result of large relative displacements of the ground along its length. Large ground movements can be caused...
Forced Vibration of Sliding Base Structural Systems
An analytical and experimental study of the effect of a horizontal sliding plane on the dynamic response of a single-story structure subjected to harmonic motion is presented. There is...
Recent Developments in Isolation Hardware
Most isolation systems have at least two physical components: one specifically intended to add flexibility and the other to control the resulting deflections. However, other elements may...
Return to search