From Good to Great: The Evolution of Cutoff Wall Quality Control and Verification Techniques
The last three decades have brought tremendous improvements to quality control (QC) procedures for construction and post-construction verification of deep cutoff walls installed in active high-hazard dams....

Working Platforms for Specialty Geo-Construction
A major cause of rigs toppling over is the state of the "working platform" that they must work from. A working platform is a layer of material, often compacted sand or gravel, placed over the subgrade,...

Your Numerical Model Begins at the Site Investigation — Phase Improving the Suitability of Numerical Geotechnical Modeling
The success of an advanced geotechnical numerical analysis depends foremost on a thorough geologic and geotechnical understanding of the site, and thus the geometric definition and adequacy of input parameters...

Moving Down the Road of Progress: Geosynthetics Subdue Failures on Expansive Clays and Frost-susceptible Soils
Using geosynthetics in roadway projects has provided sustainable alternatives for reconstruction and maintenance and now represents a significant portion of the total geosynthetics market. Geosynthetics...

Site Constraints Complicate a Bulkhead Replacement: It Takes a Team to Overcome the Challenges
North American Aggregates (NAA), a leading supplier of aggregates in the New York area, recently constructed a new processing facility in Perth Amboy, NJ. One of the final components of the new facility...

Composite Special Moment Frames
Wide Flange Beam to Concrete-Filled Steel Column Connections
Prepared by the Composite Construction Committee of the Metals Technical Administrative Committee of the Structural Engineering Institute of ASCEComposite Special Moment Frames: Wide Flange Beam to Concrete-Filled...

Highway Embankment Failure on Soft Clay: Bad Input = Bad Output
Our ability to analyze and compute 2D and 3D factors of safety for embankments and slopes, including finite element and finite difference analyses, has increased greatly in the last decade. However, use...

Big Steps for Mankind: Extraterrestrial Sampling and Exploration 50 Years after Apollo 11
Between June 1966 and January 1968, four Surveyor missions successfully landed on the Moon, collecting invaluable scientific data required to support the coming manned Apollo missions. Central to the goals...

Back in Action
At one of Northern Virginia’s most complex and notoriously congested intersections, the superstructure of a critical highway overpass was demolished, removed, and replaced in a single weekend. The design’s...

Training for Disaster
The structural complexes used to train first responders must accommodate a wide range of theoretical and practical learning. From classroom spaces to built-to-burn assemblies to buildings within buildings,...

The New Paradigm Of Post-Disaster Reconnaissance: Using Virtual Methods to Enhance Systematic In-Field Data Collection
Virtual reconnaissance is the act of gathering information after an extreme event through virtual means. This information could be data on damaged regions, cultural data for an impacted region, and previous...

Landslides Driven by Extreme Events: Can We Learn More from More of Them?
Extreme events, such as earthquakes, hurricanes, or major storms, typically cause thousands of landslides in mountainous topography over the course of minutes to hours. In the last few years alone, we’ve...

Rapid Recovery
In May 2017, the California Department of Transportation had to contend with a massive landslide that closed a section of the iconic State Route 1 through central California’s scenic coastal region of...

State of the Practice for Laboratory Testing of Soft Soils: It's All in the Details
As with all material testing, soils testing has undergone dramatic advances in technology because of computer automation. In the 1970s, laboratories were filled with dial gages, proving rings, mercury...

Rock Glue Gets the Job Done: Reducing Rockfall Hazards along the G.W. Parkway
After a large rockfall damaged the road and disrupted traffic along the George Washington Memorial Parkway in 2002, the National Park Service was looking for solutions to stabilize the slope against additional...

The Case for Tolerable Risk Guidelines to Manage Flood Risk: Nature Bats Last
Since ancient times, people have used levees to reduce flood risk. We have built over 30,000 miles of levees in the U.S., largely on the belief that levies will unconditionally protect people who live...

The Uselessness of Elephants in Compacting Fill
This article is based on an article that was originally published in the August 1967 Canadian Geotechnical Journal (Vol. IV, Number 3)....

ASCE-ASME Journal of Risk and Uncertainty in Engineering Systems, Part A: Civil Engineering
The journal will meet the needs of the researchers and engineers to address risk, disaster and failure-related challenges due to many sources and types of uncertainty in planning, design, analysis, construction,...

Journal of Transportation Engineering, Part B: Pavements
The Journal of Transportation Engineering, Part B: Pavements will contain technical and professional articles on the planning, design, construction, maintenance, and operation of airport, roadway and other...

Cracking the Nuclear Code: Finding an Alternative to the Nuclear Density Gauge
Two of the most basic quality control tests made in the field during soil construction are the soil’s moisture content and density. The establishment of a uniform procedure to compare the performance of...

 

 

 

 

Return to search