Using Geophysics to Assess Geohazards Before Construction: Increase Your Odds for Success!
Understanding subsurface conditions is the key to any successful construction project, including new construction, excavation, and drilling. The consideration and understanding of the subsurface geology...

Avoiding Impacts of Collapsed Mines on Railways: A Multidisciplinary Geophysical Detective Approach
The presence of abandoned mine workings can pose a significant risk to the use and development of surface structures above them, including railway lines. Typically, the adverse and often sudden effects...

Offshore Technology in Civil Engineering
Hall of Fame Papers: Volume 11
Prepared by the Program Committee of the Offshore Technology Conference of the Coasts, Oceans, Ports, and Rivers Institute of ASCE<\p>Offshore Technology...

Optimized Drilled Shaft Design through Post-Grouting: Shorten That Shaft for Better Performance
Tip post-grouting is a technique used to inject, under pressure, a neat cement grout beneath the base of a drilled shaft. This method enhances or improves axial load-displacement performance by increasing...

Project Layout
Microtunneling projects should be laid out with attention to the benefits and constraints unique to this construction process. The following recommendations address some of these concerns:...

Shaft Considerations
Jacking and receiving shaft locations should be selected to minimize the number of shafts and disruptions while not exceeding the practical limits of the drive lengths achievable for a...

Microtunneling Operation
The shaft should provide safe working conditions and fully support the ground. Jacking and receiving shaft support system and sizes are typically determined by the contractor. See Chapter...

Shafts/Temporary Structures
Shafts should be of a size to accommodate the equipment and pipe selected and to allow for safe working practices. If the shaft must accommodate the permanent works, it is the contractor's...

The Joint Industry Development of a Recommended Practice for the Site Specific Assessment of Mobile Jackup Units
The mobile self-elevating (drilling) unit, or jack-up, has been central to the exploration and development of offshore oil and gas reserves. In recent years there has been an increased...

Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years
Prepared by the Program Committee of the Offshore Technology Conference of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...

Offshore Jack-Up Drilling Rigs: An Engineering Challenge

Design of Deep Pier Foundations for Expansive Soils

Offshore Technology in Civil Engineering
Hall of Fame Papers From the Early Years
Prepared by the Program Committee of the Offshore Technology Conference of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...

On the Interpretation of Drilled Foundation Load Test Results

On the Axial Behavior of Drilled Foundations

Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years: Volume Seven
Prepared by the Program Committee of the Offshore Technology Conference of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...

You need to Get there Before You Can Drill

Sonic Drilling in Support of Geotechnical Investigation and Geo-Construction

Application of Horizontal Directional Drilling

Constructability Considerations When Designing Drilled Shaft Foundations for Bridges

 

 

 

 

Return to search