Grand Finale
For 87 years Oklahoma's state capitol remained unfinished, the majestic cast-in-place concrete dome its designers envisioned never built. But as Oklahoma approached its centennial�to...
Closing the Gap
In 1944 Congress authorized construction of the Foothills Parkway, a 116 km highway through the Tennessee mountains along the northwestern edge of Great Smoky Mountains National Park....
Defect Detection (Available only in Geo/Environmental Special Issue)
Sonic integrity logging technology can detect flaws in deep foundations more reliably and at less cost than conventional boring techniques. These non-destructive test tools are being used...
Interpretation of Nondestructive Integrity Tests Using Artificial Neural Networks
A barrier to more frequent use of nondestructive integrity tests on cast-in-place foundations is the difficulty of interpreting the test results to identify the presence or absence of...
Evaluation of Cast Iron Columns for Safety and Reliability
Cast iron columns exist in numerous vintage buildings. Alterations to these buildings often require analysis and modification of the structural system. This paper identifies codes that...
Structural Design on Ductile Iron Pipe
The thickness class designation for Ductile Iron pipe has been changed to a pressure class designation in the 1991 revision of the C150/A21.50 ANSI standard. However, the same conservative...
Response of Ductile Iron Pipelines at Parkfield, CA to Loma Prieta Earthquake
A field experiment designed to investigate the performance of buried pipelines at a fault crossing has been constructed at Owens' Pasture near Parkfield, CA. The site was...
Design of Ductile Iron Pipe on Supports
Design procedures for ductile iron pipe in normal underground service have been well established. The standard design considers hoop stresses in the pipe wall due to internal hydrostatic...
Corrosion Protection of Cast Iron and Ductile Iron Pipe, San Diego, California
This paper addresses the use of a loose unbonded plastic covering polyethylene encasement for protection of cast and ductile iron pipe in an extremely corrosive soil. The case study in...
Augered Cast-in-Place Piles
Development of the augered cast-in-place pile system from origination in the late 1940's to the present state of the art is presented, with methods of pile placement, including...
The Use of Restrained Joint Ductile Iron Pipe
This paper addresses some of the problems we at U. S. Pipe have observed from restrained joint installations during the past several years and the solutions devised. The restrained joints...
Thrust Restraint of Buried Ductile Iron Pipe
It is the intent of this paper to present current state of the art thrust restraint design, present a basis for calculating required lengths of restraint, and to offer some practical suggestions...
Design of Ductile Iron Pipe Systems
To ensure a reliable, low maintenance infrastructure capable of withstanding the test of time, proper initial design is essential. The basis of the design standard for ductile iron pipe...
Sliplining with Ductile Iron Pipe
The utilization of Ductile Iron Pipe (DIP) as an alternative to be considered for sliplining rehabilitation of sewer pipelines is evaluated. A recent experience in sliplining a failing...
Effects of Ground Failure on Ductile Iron Pipe
The design studies and procedures outlined in this paper for pipelines that must cross earthquake fault zones are also applicable to similar ground disturbances resulting from landslides,...
Building Bridges the Old Way
Cast-in-place concrete bridges built on falsework, particularly post-tensioned box girders, are California's dominant structure type. Factors which have led to the popularity...
The Great Highway Coverup
Public opinion has forced changes in highway design since the first ones were built 30 years ago. In the Seattle area, this environmental sensitivity led to federal court action and to...
A New Methodology for Modelling Water Pipe Breaks
A new methodology for modelling breaks in large diameter cast-iron water pipes is proposed. The need to consider two separate stages of deterioration (early stages with fewer breaks and...
State-of-the-Art Report on Steel Embedments
The basic philosophy underlying the design of steel embedments may be summarized as follows: (1) If an attachment can be located such that a group of cast-in-place anchors can be used...
Return to search