Site Constraints Complicate a Bulkhead Replacement: It Takes a Team to Overcome the Challenges
North American Aggregates (NAA), a leading supplier of aggregates in the New York area, recently constructed a new processing facility in Perth Amboy, NJ. One of the final components of the new facility...
Washington State Coastal Erosion Management Strategy
The shores of Washington's inland coast - Puget Sound - undergo chronic and episodic erosion and landsliding. The problem is not nearly so great here as elsewhere in the U.S.A., but what...
Incorporating Corrosion in Reliability-Based Design of Anchored Bulkheads
Corrosion of steel is an important factor in the design of marine structures. A reliability analysis of anchored bulkheads showed that corrosion changes the critical failure mode from...
Design and Construction of Waterfront Facilities at U.S. Navy Homeport at Ingleside, Texas
The waterfront facilities for the largest of the Navy's new homeports in the Gulf of Mexico were completed in 1990. The project included over 2,500 feet (762 m.) of deep draft bulkhead...
Replacement of a Deteriorated Steel Sheet Pile Bulkhead
This paper presents a life history of a marine steel sheet pile bulkhead, over 35 years old, that has been exposed to a salt water environment with minimal maintenance or repair in the...
Shore Protection Construction Along the California Coast
Severe beach, cliff and bluff erosion is occurring along the urban communities on the 1800 miles of ocean, bay and estuarine shoreline of California. This report is an overview of the...
Dewatering Using a Floating Bulkhead Proves Flexible, Reusable and Cost Effective
Going beyond a traditional bulkhead dropped in place with a barge crane or crane hoist, a steel floating bulkhead was conceived to dewater powerplant intakes, gated spillway bays or outlet...
Handling of Intake Bulkhead at King Talal Dam
During raising of King Talal Dam in Jordan in 1986, the existing intake wheel gate provided at the inlet of the project Low Level Outlet Works (LLOW) tunnel was found inadequate to withstand...
Bulkhead Instability in Soft Soil
This paper presents a case study involving the severe disturbance of the subsurface soils in front of an existing bulkhead caused by the berthing of a jack-up type, offshore drilling vessel....
Timber Bulkheads
Timber bulkhead design and construction methods are presented in this publication for consideration by the engineering profession. Included are papers on an analytical method for the design...
Innovative Bulkhead Design: Third Port Project?St. Croix, U.S. Virgin Islands
This paper describes an innovative design making use of a 'master pile' bulkhead to support the waterside rail for travelling container cranes as well as to retain...
Port of Kismayo (Somalia) Rehabilitation
Extensive deterioration of the 2070 ft long four-berth, marginal wharf at the Port of Kismayo necessitated a major rehabilitation to maintain operations. The selected scheme was a steel...
Tiebacks for Bulkheads
Tiebacks were once used primarily to support temporary structures such as supported excavations. However, the use of tiebacks has been gradually expanded to include the support of permanent...
Return to search