Consistency and Fairness in Geotextile Specifications
By clearly defining required material properties in terms of 'Minimum Average Roll Values' for routine quality control tests and 'Average Test Values in the Weakest Principal Direction'...

Concreting at Subfreezing Temperatures
Temperature affects the rate at which portland cement concrete develops strength. Below about 20?C, strength gain is retarded, whereas at higher temperatures it is accelerated. Strength...

Aerogel?A Transparent, Porous Superinsulator
Silica aerogel is an unusual, transparent, low density, thermally insulating solid useful for a variety of applications. We have been investigating silica aerogel for use in transparent...

Physicochemical and Rheological Properties of Microwave Recyled Asphalt Binders
The purpose of this study was to analyze microwave recycled asphalt binders using Gel Permeation Chromatography (GPC), Fourier-Transform Infrared Spectroscopy (FTIR), and Dynamic Mechanical...

Concrete Surface Treatments?A Selection Guide
Concrete deterioration can take many forms. The most common forms of concrete surface deterioration includes delaminations, spalling and scaling. This deterioration is usually caused by...

Composites Performance in the Infrastructure
Fiberglass reinforced plastics (FRP) composites have been used in demanding structural applications, mostly for special corrosion resistant construction products, for several decades....

Unidirected Twined-Strand Composites and Their Uses
Twined strand composites are a new class of unidirected continuous-fiber-reinforced composite materials where the orientation of the continuous fibers is a twine of unidirected helically...

Full Scale Tests on Concentrically Loaded Fiber-Reinforced Pultruded Columns
This paper briefly reports on the experimental investigation in connection with the short term behavior of pultruded structural members under concentric loading. In particular, results...

Evaluation of Partial Depth Spall Repair Materials and Procedures
In 1990, as a part of a Strategic Highway Research Program project (SHRP H-106, Innovative Materials Development and Testing), an investigation was initiated to evaluate the performance...

Stability and Performance of Slopes and Embankments II
This proceedings, Stability and Performance of Slopes and Embankments II, consists of papers presented at the Specialty Conference sponsored...

Embankment Dams
James L. Sherard Contributions
This volume is dedicated to the memory of Dr. James L. Sherard, who made many contributions to embankment dam engineering. Twenty-one of his papers related to this topic were selected...

Soil-Pile-Superstructure System in Liquefaction
To obtain the dynamic behavior of the soil-pile-superstructure system in a liquefied sand layer, shaking table tests by using large scale shear bin (4m in length, 2m in width and 2m in...

Hydraulic Engineering
Saving a Threatened Resource?In Search of Solutions
This proceedings, Hydraulic Engineering: Saving a Threatened Resource?In Search of Solutions, cotains papers presented at the 1992 National...

Risk-Based Decision Making in Water Resources V
This proceedings, Risk-Based Decision Making in Water Resources V, contains edited papers presented at the Fifth Engineering Foundation Conference...

Pipeline Storm Behavior on Clay Soils
A series of transverse wave loading tests was conducted on a specially mounted section of pipe in a sediment-filled tank, to investigate the stability of unburied submarine pipelines under...

Hydraulic Design of Offshore Breakwater in Sergipe, Brazil
A Petrobras (Petroleo Brasileiro S.A.) marine terminal was recently constructed in Sergipe, Brazil (Figure 1). The offshore breakwater was initially designed in a conventional way, but...

Stability of Accropode(R) and Comparison with Parallelepipedic Block
This paper describes the tests which were performed on physical models with irregular waves, to determine the hydraulic stability of the Accropode(R)...

Effects of Freezing on Impact Properties of RTM Composites, and Their Applications in Offshore Structures
Resin transfer molding is rapidly being acknowledged as the process with potential to create perhaps the purest form of a composite material as representative of the concept of `material-by-design.'...

RCC at 10
Tens years after the first roller-compacted concrete (RCC) dam in the U.S.�the 169 ft high Willow Creek Dam in Oregon�was completed, the method has gained wide acceptance around the world...

Soil-Pipe Interaction During Frost Heaving Around a Buried Chilled Pipeline
The freezing of soil water around a buried chilled pipeline leads to soil heaving, which is affected by the presence of the pipe. This process may eventually cause pipeline failure. The...

 

 

 

 

Return to search