Modal Filter Based Structural Control of a Highway Bridge
An Adaptive Modal Filter (AMF) algorithm is developed which uncouples complicated multi-mode structural dynamic response into simple single-mode response. The application to active structural...
Computing in Analysis and Design in Structural Engineering Education, Practice and Registration - A Rationale for Dialogue
Structural analysis and design are increasingly being taught using personal computers, workstations or mainframe computers at the universities. The structural engineering designs in small...
Computing in Analysis and Design in Structural Engineering - An Educator's Point of View
The use of the computer in structural engineering education is discussed. It is emphasized that the students must have an understanding of both the analysis process and the behavior of...
Computing and Design in Structural Engineering A Practicing Engineer's Point of View
The development of the electronic computational power of the computer has been a boon to the structural engineering profession. The resulting increases in the speed and efficiency of the...
Computing in Analysis and Design in Structural Engineering Education, Practice and Registration: A View from the National Council of Examiners for Engineering and Surveying
When taking the examinations for licensure as professional engineers, computers are not allowed. The knowledge tested on the Structural Engineering examinations are discussed with a sample...
Validation of a Continental-Scale Storm Surge Model for the Coast of Delaware
Coastal structures are designed to provide protection against various forces of nature acting in the coastal zone. Structures such as seawalls are expected to provide onshore protection...
Localized Sigma Coordinates for the Vertical Structure of Hydrodynamic Models
This paper analyzes the use of localized sigma coordinates in the numerical solution of the vertical structure of coastal flows. We show, through a combination of truncation error analysis...
Design, Construction, and Maintenance of Relief Wells
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers, No. 3 This engineering manual provides guidance and information...
Storage Tanks: Going Above Ground
Until just a few years ago, the traditional replacement for a leaking underground storage tank was a new UST. But in September 1988, EPA finalized new regulations for UST systems containing...
Boston's Backup Water Supply
For fifty years, Boston's sole real source of water has been the Hultman Aqueduct, but now final design is almost complete on the MetroWest Supply Tunnel, a new, larger conduit...
An Experimental and Analytical Study of the Shoreline Response to Non-Parallel Breakwaters in Oblique Waves
REsults of an experimental and analysis study single breakwaters on oblique waves are presented. Three orientations of the breakwaters are studied, those being parallel to the shoreline,...
Wave Run-Up and Reflection on a Permeable Sea Wall
The swash oscillation on a sloping seawall made of step-shaped concrete blocks, waves and water particle velocity in front of the seawall were measured. It was inferred that incident waves...
Wave Transformation and Load Reduction Using a Small Tandem Reef Breakwater ? Physical Model Tests
The performance of several small reef breakwaters, and a tandem breakwater system (consisting of a reef breakwater positioned upwave from a surface-piercing main breakwater), are quantified...
The Evolution of Breakwater Design
The purpose of this paper is to present a view of the evolution of both the rubble mound and vertical faced breakwaters from the earliest design through the Iribarren and Hudson era. Determining...
Dynamic Loading of Airfield Pavements Caused by Aircraft Operations on Rough Runways
This paper presents results for dynamic pavement loading of various aircraft under takeoff and taxing scenarios. The data were obtained from computer simulation and applied to the Corps...
Implementation of Elastic Layered Theory for Design of Unbonded Overlays
The U.S. Army and Air Force have implemented the elastic layered theory for design of unbonded overlays for rigid airfield pavements. The procedure allows for design of unbonded overlays...
Joint Probability Distribution of Rainfall Intensity and Duration
Intensity-duration-frequency (IDF) curves are widely used for peak discharge estimation in designing hydraulic structures. Accurate interpolated and extrapolated intensity values are difficult...
Integration of Reliability, Uncertainty and Optimization in Hydraulics Systems: Structural Reliability
The focus of this paper is to provide an overview of analysis and optimal design of systems in which the system reliability is dependent upon the structure of the system (such as the layout...
Reliability Analysis of a Multi-Reservoir Water Distribution System
A methodology for evaluating system reliability is developed to assist in the planning and management of a multi-reservoir water distribution system. The minimum cut-set approach is employed...
Concrete Watertight Structures and Hazardous Liquid Containment
The purpose of
Return to search