Liquefaction Evaluation by Seismic Potential Procedure
Empirical procedures in common use for liquefaction evaluation employ information from a variety of sources in order to evaluate whether or not a site will undergo liquefaction. The information...
Software Applications for Monitoring Instrumentation Data
The initial program for reducing instrumentation data, used by the Geotechnical Branch of the Louisville District Corps of Engineers, was written in 1969. This program did not allow for...
Evaluation of Rehabilitation Needs for Hydraulic-Fill Dam
This paper describes the application of analytical methodologies developed for seismic stability analysis of dams in the western U.S. (particularly the Lower San Fernando Dam in Southern...
Testing and Evaluation of High Capacity, Multi-Strand Rock Anchors for Lake Lynn Dam
Seventy five rock anchors with design loads of 556 to 2040 kips were required for the 1000-foot long, 125-foot high, concrete gravity, Lake Lynn Dam to comply with current FERC engineering...
Ultrafine Cement Tests and Drilling Warm Springs Dam
Ultrafine cement was chosen by the Corps of Engineers for tertiary grouting the Warm Springs Dam because of its ultrafine particle size, low settlement, medium viscosity and longevity....
Experimental Evaluation of Reservoir Bottom Remediation Material
Open trenches developed through a compacted clay liner on the bottom of a reservoir. An experimental investigation has been conducted to evaluate the feasibility of using silt-sized, nonplastic...
Coolidge Dam Abutment Stability and Stabilization
This paper focuses on left abutment stability assessments and stabilization measures at Coolidge Dam, Arizona. Initial assessment of abutment stability was based on limited rock strength...
Seismic Stability Modification Requirements for Pineview Dam
Pineview Dam is located 8 km upstream from Ogden, Utah, and about 8 km from the Wasatch Fault Zone. Preconstruction information and construction records available at the outset of the...
The Causticity of Accelerator for Shotcrete and its Impairment on Strength of Shotcrete
How on earth is the toxic and caustic injury of accelerator for shotcrete to operators and animals? How about its impairment on strength of shotcrete? The paper gives some reports and...
Large Scale Testing of Shotcrete
A large scale test program was carried out to evaluate the relative roles of steel fiber and mesh reinforced shotcrete for hard rock stabilization. The most realistic conditions in a tunnel...
Supply-Side Solutions
Although the crumbling bridge infrastructure has received much attention in the press and the engineering community over the past few years, the number of structurally deficient bridges...
Cask Storage Verification Test?Full Scale Test
In Japan, the cask-storage method of spent fuel will be licensed in the near future and the related R&D works (partly of the Japanese Government have been carried out mainly by...
The Most Likely Groundwater Flux Through the Unsaturated Tuff Matrix at USW H-1
Using a probabilistic inverse method, an estimate is made of the groundwater flux through the unsaturated tuff matrix at drill hole USW H-1 in Yucca Mountain. The most likely flux is found...
U.S. Nuclear Regulatory Commission Staff Technical Position on Investigations to Identify Fault Displacement Hazards and Seismic Hazards at a Geologic Repository
This paper outlines the guidance provided to the U.S. Department of Energy by the Nuclear Regulatory Commission (NRC) staff in its Staff Technical Position (STP) on appropriate investigations...
Marginal Overweight Operating Scenario for DOE's Initiative I Highway Casks
This paper assesses the potential transport of high-capacity Initiative I highway casks under development by the Office of Civilian Radioactive Waste Management (OCRWM) as permitted marginal...
Testing Models of Flow and Transport in Unsaturated Porous Media
The design of an intermediate-scale flow and transport experiment in an unsaturated porous media is described. This experiment will be conducted a 3-m-diameter by 6-m-long caisson filled...
Simulation of Fracture Flow to the Kamaishi Validation Drift
The Power Reactor and Nuclear Fuel Development Corporation (PNC) has developed an in-situ test facility in the Kamaishi Mine to resolve technical issues in disposal of radioactive wastes...
Modelling Colloidal Transport of Radionuclides Through Porous Media
General acknowledgement of the potential role of colloids in enhancing radionuclide transport has prompted the preliminary development of a mechanistic colloid transport model as part...
Field Investigation of Mining-Induced Seismicity on Local Geohydrology
Hydraulic response of the rock mass due to earthquakes is one of the concerns in the assessment of the long-term performance of a repository. Studies performed by other researchers indicated...
Single-Hole in Situ Thermal Probe for Hydrothermal Characterization at Yucca Mountain
The REKA thermal probe method, which uses a single borehole to measure in situ rock thermophysical properties and provides for efficient and low-cost site characterization, is analyzed...
Return to search