Determination of In-Situ Stresses From Acoustic Emissions
Acoustic emissions (AE) are microseismic activities that are generated in concrete by cracking and damage. The rate of Acoustic Emissions, called the 'Event Rate', can provide indication...
Evaluating Polymer Concrete Bridge Expansion Joints Using Acoustic Emission
This study is to simulate the acoustic emission (A/E) of polymer concrete bridge expansion joints subjected to controlled representative loads by a rotating test apparatus on a circular...
Detection of Cracks in Reinforced Concrete Cans
The Acoustic Emission Technique (AET) is known as a good possibility for non destructive detection of cracks in metal down to very small dimensions. To use AET for concrete, an efficient...
Micromechanical Simulation of Wave Propagation in Dense Granular Assemblies
Two-dimensional DEM with modified Mindlin's contact law has been used to study the load transfer mechanisms in 'consolidated' granular assemblies. Results of simulation are presented and...
Neural Network Modeling of the Mechanical Behavior of Sand
Given a set of triaxial test data, an artificial neural network (ANN) has been trained to model the mechanical behavior of a medium-to-fine sand. Once trained, the ANN was tested by simulating...
Computer Simulation of Direct Shear Test
This paper presents a pilot study of a computer simulation of direct shear test on sands using the Discrete Element Method. The numerical test setup is described first, which is followed...
Numerical Integration of Transient Creep Constitutive Equations for Polycrystalline Ice
A numerical time integration algorithm is developed to solved the system of coupled, first-order differential equations characterizing the physically-based constitutive model of Shyam...
Stochastic Modeling of Fatigue Crack Growth with Retardation
This paper develops a new methodology for modeling fatigue crack growth accounting for both material inhomogeneity and the random nature of the loading process by modeling the crack growth...
Probabilistic Micromechanics in Constitutive Modeling of Granular Material
This paper gives a review of newly developed probabilistic methods for analysis of the effect of randomness in geometry and physical properties at the microscale on their macroscale response...
Joint Network Modeling and Scale Effects in Rock
Joint networks play a vital role in the mechanical and hydraulic behavior of rock masses. A realistic representation of joint geometry in rock masses and correct understanding of the mechanical...
Constitutive Modeling for Material with Perfect Disordered Heterogeneity
Finite element analysis with large number of elements are performed to simulate perfect disordered heterogenous material. The probabilistic nature of the micromechanical behavior of the...
Improved Time-History Analysis for Structural Dynamics Calculations
Methods are developed to reduce the computational effort in time-history analysis of nonlinear structures. The methods permit use of much larger time intervals than are possible in conventional...
Modal Coupling Effect of Non-Classically Damping
The equations of motion of a structure in undamped modal coordinates may have non-zero off-diagonal terms in the damping matrix. Although these terms are commonly neglected, studies have...
Nonlinear Dynamic Response of Framed Structures Using the Mode Superposition Method
This paper describes a methodology for nonlinear dynamic response analysis of framed structures using the mode superposition method. A portal frame example is presented and compared to...
Free Vibration Analysis of Asymmetric Buildings
A simple procedure for free vibration analysis of asymmetric buildings is presented. This method assumes that each floor is a rigid diaphragm with three degrees of freedom (two lateral...
Wave Induced Vortex Near Seashore
The vortex motion behind submerged breakwaters in the nearshore region is studied. The RCPWAVE model (Ebersole et al., 1986) is used to calculate the wave field and thus the radiator stresses...
The Flow in the Front Stagnation Region of a Square Plate with a Small Disturbing Wire in its Upstream
The flow in the front stagnation region of a square plate was investigated experimentally in a water channel. A small wire was placed in the upstream of the square plate to create a small...
The Transverse Vortex in the Wall Regions of the Turbulent Boundary Layers in the Flows with Adverse Pressure Gradient
The vortical structures in the turbulent boundary layers in the flow with adverse pressure gradient were investigated by the hydrogen bubble technique. The vortices were visualized in...
Vortex Suppression in Wet-Pit Pump Intakes
Two distinct examples to suppress both air-entraining and boundary-attached subsurface vortices in large vertical pump intakes are presented that were developed by means of hydraulic model...
On the Modelling of Damage Due to Volumic Variations in Cementitious Composites
Two kinds of volumic variations are considered. Those due to thermal gradients on hardened concrete and those due to hydration processes at early ages. Models based on damage mechanics...
Return to search