Fire Endurance Model for a Metal-Plate-Connected Wood Truss
A numerical model has been developed for predicting the fire endurance of a single metal-plate-connected wood truss. Extensive component fire testing was conducted to develop the necessary...

A Wind Tunnel Study of an Aeroelastic Model of the Florida Suncoast Dome
Very large scale cable domes have been built using prestressed, high strength steel cable or strand, steel tube columns and a lightweight fiberglass skin. Geiger Engineers Florida Suncoast...

Effects of Drifting on Snow Loads on Large Roofs
In areas that experience significant snow fall, snow loads typically produce the governing environmental load cases for a large span roof. Therefore for large span roofs there are considerable...

Predicting Turbine-Generator Foundation Vibrations
Two of the major considerations in the design of large turbine-generator foundations are to maintain the proper shaft alignment and to limit the vibration of the machine during operation....

On the Numerical Simulation of Wind Loads on Structures
A new methodology for numerical simulation of 3-dimensional turbulent flow based on the use of a Galilean frame and the finite point method is presented. The pressure field of the solutions...

Development of Computer-Based Models of Standards and Attendant Knowledge-Base and Procedural Systems
Existing and new technology can be used to develop a new generation of standards that would allow designers to use complex standards efficiently, help standard-writing bodies to detect...

Parametric Study of Cable-Stayed Bridges Response Due to Traffic-Induced Vibration
The dynamic response of long-span cable-stayed bridges due to moving traffic loads is investigated utilizing three-dimensional models. Modal analysis is conducted using the deformed dead-load...

Steel Alternates for the Hoover Dam Bridge
As input to the Environmental Impact Statement studies of appropriate long span bridges were performed for three alternate corridors across the Colorado River near Hoover Dam. Details...

Bonded Polyester Concrete Overlays Used in California
Bonded polyester concrete overlays have been very successful in California in restoring and preserving bridge decks from damage by road salts. The polyester concrete system has been employed...

After-Fracture Response of a Two-Girder Steel Bridge
The I-40 bridges over the Rio Grande are due to be razed in mid 1993 due to geometry and traffic safety considerations. The bridges are classified as 'fracture critical' two girder steel...

Full-Scale Bridge Test to Monitor Vibrational Signatures
A full-scale highway bridge, in the process of being demolished and replaced was monitored using vibrational techniques in its in-service condition. The bottom flange and web of one fascia...

An Efficient Analysis of Framed-Tube Structures
An efficient model for analysis of framed-tube systems is proposed in this study. The proposed model can represent the interaction between plane frames consisting the tube system. Analysis...

Nonlinear Dynamic Analysis of Structural Frames Using Reduced Order Models
In order to provide more realistic and economical design of large structures it is necessary to perform analyses which take into account both material and geometric nonlinearities. Unfortunately,...

A Shear Transfer Model for Floor-To-Wall Connections in Concrete Masonry Structures
Based upon experiments conducted at the Univ of California, San Diego (UCSD) on floor-to-wall connections in concrete masonry structures, a constitutive model was developed for the overall...

Analysis of Masonry Walls with Smeared and Discrete Crack Models
To design modern reinforced masonry structures for seismic loads and to evaluate the seismic safety of existing unreinforced masonry buildings, the shear resistance of masonry shear walls...

Three-Dimensional Analysis Model for Complete Masonry Buildings
For the predictive and diagnostic analysis of the complete nonlinear response of masonry buildings to seismic load input, a 3-D finite element model is under development at UCSD. The model,...

New Views for Modeling Dynamic Response of URM Buildings
Various computational models are used to depict seismic response of an unreinforced masonry building that was subjected to the 1989 Loma Prieta Earthquake. The worthiness of various analytical...

An Overview of the Potential Applications of Neural Networks in Civil Engineering
Neural networks are computational models inspired by the structure and operation of the brain. They are massively parallel systems, made up of a large number of highly interconnected,...

Mapping Structural Damage to Monetary Damage
Earthquake damage estimation/prediction is still an area which requires expertise and judgment of the experts in the field. Making the predictions/estimates more accurate is an area of...

Time Variant Reliability Under Environmental Loads
Time variant reliability with deteriorating resistance under a stochastic load process is considered. An outcrossing formulation for fatigue degradation is presented, and a simple and...

 

 

 

 

Return to search