Alongshore Sediment Transport Rate Distribution
The initial analysis of a new set of experimental data on alongshore sediment transport rate distribution is presented. The distributions were generally found to be bimodal but tended...
A Calibrated Longshore Transport Model for Richards Bay
In order to plan maintenance dredging at the Port of Richards Bay, different studies were carried out. These were to determine the extreme dredging rates required in the long term and...
Shear Velocity and Eolian Sand Transport on a Barrier Island
Nearly 18 months of simultaneous measurements of atmospheric shear velocity, sand transport quantity, and beach erosion survey were made to investigate the rate of eolian sand transport...
Suspended Sediment Load at Three Time Scales
Suspended sediment loads were examined at the three time scales of time-series-averaged, wave-by-wave and instantaneous during the wave cycle. Field measurements recorded on a natural...
Sediment Transport by Strong Wave-Plus-Current Flows
A prediction formula is derived for the suspended sediment transport rate in coastal regions when the current speed and/or wave orbital velocity is large. It is based on generalised forms...
Cross-Shore Sediment Transport Under Irregular Waves in Surf Zones
A numerical model is proposed to predict the free surface elevation and depth-averaged velocity in the surf and swash zones for normally incident random waves. Comparison of the numerical...
Simulation of Bedload Transport of Marine Gravel
Using combined current meter and acoustic measurements, detailed concurrent time series of instantaneous bedload transport rates and flow turbulence have been obtained. The duration, interval...
Bedload Transport Measurement by Imaging of Tracers
A dyed-sand tracer technique is developed for investigation of bedload under laboratory oscillatory flows. Imaging of the tracer with high speed photography allows the creation of time...
Bedload Transport Under Low Frequency Waves
The concept of a bedload spectrum, showing the distribution of energy with frequency in the bedload process, is proposed. The bedload process is thus analysed in the frequency rather than...
The Effect of Beach Slope on Oscillatory Flow Bedload Transport
The data for five laboratory sloping bed bedload sediment transport experiments are presented. Each consists of a series of half cycle transport rate measurements using the same waveform...
Sedimentation Processes in Morro Bay, California
A series of field investigations and historical data analyses were conducted to determine historical sedimentation processes in Morro Bay, California. Three sources of sediment were identified:...
Field Application of a Numerical Model of Beach Topography Change
Discussion was made, on the basis of field data, on the applicability of the formula for local rate of sediment transport due to combined action of waves and currents presented by Watanabe...
Higher Frequency Acoustic Measurements of Coarse Bedload Transport
Although sensors have been developed which provide high temporal resolution for the measurement of wave profiles, flow fields and suspended sediment concentrations within the coastal system,...
Standing Wave Measurements of Bedload Thickness: Feasibility in an Air System with Model Sediment
A novel technique would yield information about bedload thickness from measurements of a standing wave pattern produced by a sound source insonifying the bottom at normal incidence. The...
Pilot-scale Trickling Filter Nitrification at the Longmont WWTP
Nitrification rates in trickling filters can be affected by influent organic matter, filter length, and hydraulic loading rate. The effects of these parameters on nitrification rate were...
Inventory of Constructed Wetlands for Municipal Wastewater Treatment in the U.S.
The U.S. EPA's Risk Reduction Engineering Laboratory is conducting an inventory of constructed wetlands (CW) for municipal wastewater treatment in the U.S. The inventory is...
Vacuum Anaerobic Treatment: A New Approach
Anaerobic processes have an organic loading limit that when exceeded leads to process failure. The research summarized in this paper demonstrates that both organic removal rate enhancement...
LRFD: Still Waiting
Introduced in 1986, load and resistance factor design (LRFD), has a way to go before it becomes standard practice for steel design. LRFD-based design typically results in savings on gravity...
Probing the Golden Gate
The Golden Gate Bridge has just come through the most detailed analysis ever attempted in its 53-year-old history. This analysis was squeezed into a desktop computer that calculates twice...
Evaluating the Dynamic Operating Benefits of Hydro Power Plants
In 1986, the Electric Power Research Institute asked Decision Focus to develop a new planning model to quantify the dynamic operating benefits of power technologies that offer operating...
Return to search