Theoretical Study on Capture Chamber with Lateral Entrance
A capture chamber with lateral entrance can be used in a pneumatic wave energy conversion system. In this paper, the output power coefficients of the capture chamber have been calculated...
Research and Development of Wave Pump
A new device, 'Wave Pump' is introduced here. The authors present the mechanism of the system, the analytical method for discharge rate, the hydraulic model test...
Water Power Resource Investigations in New Zealand
The New Zealand wave resource is dominated by strong uniform swell incident on its western and southern coasts. Electricorp Production has funded the deployment of a wave rider buoy off...
Wave Power Development in Taiwan
The feasibility study of wave power development in Taiwan was performed in two phases. The first phase included the calculation and assessment of the available wave energy along the coasts...
Progress of Floating Type Wave Power Generator
A floating type wave power generator was improved. It is a Backward Bent Duct Buoy (BBDB) which has an air chamber duct which is bent backwards. It is capable of increasing the peak conversion...
Planning a Full Scale Wave Power Conversion Test 1988-1989
The paper describes the design of the wave power converter and the principal of working. The results from a tank test on a scale model are presented with the main emphasis on design loads...
Double-OWC Wave Power Extractor of a Taut Moored Floating Structure
A double oscillating water column is proposed as a means to improve the efficiency of wave power conversion over a wide range of wave periods in deep water. A mathematical model of the...
Use of Scrap Tires to Harness Wave Energy
A 2.5 meter diameter wave powered pump, fabricated from scrap tires was tested from May 24, 1988 to October 1988 in the Atlantic Ocean at the North Carolina Army Corp of Engineers Waterways...
Estimation of Wave Power as an Energy Resource for Hawaii
One of the most important elements in determining the wave power available by means of a wave power extracting device is the amount of wave energy present at a given location during a...
Reliability Assessment of Wood Components
Considerable progress has been made in the nondestructive evaluation (NDE) of wood components since the introduction of the first concepts more than twenty-five years ago. New stress wave...
Probabilistic Prediction of Losses to Lifeline Systems Due to Earthquakes
An efficient and practical method for earthquake loss estimation for lifelines is developed, using the recent advances made in the areas of lifeline earthquake engineering and probabilistic...
Aussie Steel
The 50-story Chifley Square Building being built in Sydney will be the tallest Australian steel building. Scheduled for completion in June 1992 at a cost of $310 million, it will house...
Wind Bracing
This chapter discusses the structural design of the bridge with regards to wind forces....
Transmission Line Structure Loading
This paper outlines specific procedures for determining loads on transmission line structure systems that can be used in the reliability based design or assessment of components of these...
Sizing Techniques for Lateral Bracing
Techniques for determining the size of lateral bracing members in multi-story steel buildings are presented and discussed. Because the design of such bracing is usually controlled by deflection...
Steel Girt Design
Procedures are presented for the design of light gage cold formed girts and hot rolled girts. The effects of continuity, sag rods, and wall sheeting are discussed. Design procedures are...
NDE for Performance of Wood Structures
Significant economic losses result annually due to deterioration and failure of structural wood components. A high percentage of these losses result from our current inability to assess...
Aerodynamic Improvements for Plate-Girder Bridges
This paper describes the application of wind tunnel tests on plate-girder cable-stayed bridges to ensure that the cross-section will not be susceptible to wind-induced oscillations. Information...
Inclined-Cable Aerodynamics
A series of wind tunnel tests have been conducted to clarify the fundamental mechanism of the vibration of the inclined cables of cable stayed bridges. The influence of the cable orientation...
Lateral Force Distribution in Manufactured Housing from Full-Scale Testing
The research focused on the behavior of two manufactured 14 ? 66 ft houses under simulated wind loads. Extensive instrumentation was employed to insure the collection of data that would...
Return to search