Finite-Strain Axial Analysis of Piles in Clay
In the late 1970's, a series of research projects developed simple effective-stress methods to predict the axial capacity of piles in normally-consolidated clay. The method...
Centrifugal Modeling of Pile Foundations
Modeling of pile foundations in a centrifuge, where the self weight induced stresses in the soil are simulated by elevated gravity loading, is described. Hollow pipe piles in a stiff clay...
Prediction of Settlement of Single Piles in Clay
Analyses by trial were used to fit theoretical load-settlement curves to measured curves for driven piles. For the elastic method, analyses of load tests indicated that designers should...
A Flat-Dilatometer Study of Lateral Soil Response
The effect of flat dilatometer penetration on the lateral stress conditions in soil around the dilatometer blade and the soil response against dilatometer diaphragm deflection were investigated...
The Simple-Pile Approach to Pile Installation in Clays
This article describes the fundamentals of the approach and presents solutions for the effects of quasi-static deep undrained penetration of a simple solid pile on the deformations and...
Study on Secondary Compression of Clays
An elastoviscoplastic constitutive model shows that a strain rate effect parameter is related to the coefficient of secondary compression. The relation was verified experimentally by test...
Yield Behaviour and Consolidation. I: Pore Pressure Response
This paper discusses the frequency of occurrence of anomalous consolidation behaviour. The behaviour of soft clay is discussed briefly in terms of the effective stress path/yield envelope...
Time and Stress Dependent Compression in Soft Sediments
Results are presented for laboratory experiments using a typical estuarine mud settling from a slurry in columns of 100mm diameter. Measurements have been made of density and pore water...
Instrumentation Performance in Soft Clay Soils (A Case History)
In 1978, IDEAL BASIC INDUSTRIES, INC. initiated construction of a cement manufacturing plant located south of Mobile, Alabama on the Theodore Ship Channel. Because deltaic clays were too...
Waste Phosphatic Clay Disposal in Mine Cutsr
Research was undertaken to assess the applicability of waste clay disposal back into phosphate mine cuts. The pit was monitored for two years with measurements of clay surface elevation,...
Influence of Roughness on Velocity and Dispersion at Low Flow
Dependence of the hydraulic and transport characteristics of low flow on channel roughness is investigated. Empirical expressions are used to estimate roughness coefficient as a function...
Effects of High Sediment Concentrations on Velocity and Sediment Distributions
Several classifications are required to describe sediment-transporting flow. The flow may be turbulent or laminar, Newtonian or non-Newtonian, and may also have a uniform or nonuniform...
Flow Parameters of Fluid Mud
A set of small-scale, high-resolution velocity and stress sensors based on rugged metal-clad hot wires and epoxy-encapsulated hot films is to be evaluated for its performance characteristics...
Plunge Pool Erosion in Cohesive Soils at Two Dams in Kansas
Results of a field study of two plunge pools scoured by horizontal pipe outlets discharging on cohesive channels are analyzed. Formulas for critical tractive shear stress based on plasticity...
Prediction of Dam Overtopping Due to Mudflows
The eruption of Mount St. Helens on May 18, 1980 resulted in a small mudflow into Swift reservoir, which is located immediately south of the mountain. An engineering/geologic study was...
Optimal Real-Time Operation of a Cascade of Hydropower Plants in Central West China
The Longxihe River hydropower system consists of four hydropower plants in series. The four reservoirs are used for flood control and power generation. Among the four reservoirs, only...
Artificially Varied Flow: River System Management
Some of the major water quality problems are heat, color, organic sediment, and total dissolved solids. To dilute these and other pollutants, substantial augmentation of flows for water...
Sensitivity of Model Choice in Reservoir Design
The Box-Jenkins method of model construction and tests of model adequacy and fit are applied to a reservoir design problem. The sensitivity of the stochastic models used to generate synthetic...
Modeling Pool and Riffle Sequences in Alluvial Channels
A one-dimensional mathematical model has been developed to predict the hydraulic characteristics of alluvial channels under low flow conditions. For a given steady discharge, channel geometry,...
Measurement of Ice Forces on Structures
Methodologies and techniques are discussed for measuring ice forces on fixed structures situated in rivers and lakes. The usual method of measuring ice forces is to place a load frame...
Return to search