Mitigation of Wind-Created Risks During Construction
Wind damage to structures during construction has been found to be significant and often catastrophic. Structural failures are often the result of wind loads that are far less than the...
Investigation of Full-Scale Performance of Structures?Research Potentials
It is well known that actual, or true, behavior of completed structures does not necessarily conform to often simplified analysis predictions. This may be due to any of several reasons...
Parametric Study of Cable-Stayed Bridges Response Due to Traffic-Induced Vibration
The dynamic response of long-span cable-stayed bridges due to moving traffic loads is investigated utilizing three-dimensional models. Modal analysis is conducted using the deformed dead-load...
Linear and Nonlinear Finite Element Analyses of RC Skewed Slab Bridges with Integral Wall Abutments
The design of rigid-frame skewed slab bridges is complicated by higher shears and moments near the obtuse corner (see Fig.1). While the finite element method can be used to compute these...
Experimental Testing of Laterally Loaded Large Scale Bridge Abutments
The challenges to a bridge analyst in defining abutment boundary conditions and the current state of the practice are presented. Variables within the abutment system are defined and discussed...
Modal Analysis Technique for Bridge Damage Detection
The dynamic responses of a wide-flange steel beam with artificially introduced cracks were studied analytically and experimentally. Frequencies, displacement mode shapes (DMS) and strain...
Correction Factor Method for Building Analysis Under Sequential Dead Loads
The effect of the sequential application of dead load due to the sequential nature of construction is an important factor to be considered in the multistory frame analysis. One of the...
An Efficient Analysis of Framed-Tube Structures
An efficient model for analysis of framed-tube systems is proposed in this study. The proposed model can represent the interaction between plane frames consisting the tube system. Analysis...
Dynamic Inelastic Analysis of Tall Buildings
Members with undesirably early formed plastic hinges as well as excessive conservatism introduced in the preliminary design of tall buildings can be identified by the behavior state study...
Floor Response Spectra Analysis Including Correlations of Multiple Support Motions
This paper deals with the response spectrum analysis method of the secondary structures including the correlation effects between nonuniform support excitations. Based on the random vibration...
Damage Estimation of Existing Bridge Structures
During recent earthquakes, severe damage have been reported in many bridge structures. Regardless of many damaged structures, methods to identify damage of structures are still limited...
Nonlinear Dynamic Analysis of Single Point Moored Buoy Under Wave and Current Loadings
In this study, a single point moored spherical buoy under wave and current loadings is analyzed in the time domain considering time memory effects. Geometric nonlinearity of the mooring...
Nonlinear Dynamic Analysis of Structural Frames Using Reduced Order Models
In order to provide more realistic and economical design of large structures it is necessary to perform analyses which take into account both material and geometric nonlinearities. Unfortunately,...
A Reduced Order Model for the Seismic Analysis of Building-Soil Systems
A finite element based, reduced order, numerical model has been developed for the nonlinear analysis of building-soil systems. The reduced order system model employs an equivalent continuum...
Development of an Improved Rapid Seismic Analysis Procedure
New developments in computer capabilities and lessons learned from recent earthquakes have facilitated improvement of the Rapid Seismic Analysis Procedure (RSAP) currently specified in...
Analysis of Masonry Walls with Smeared and Discrete Crack Models
To design modern reinforced masonry structures for seismic loads and to evaluate the seismic safety of existing unreinforced masonry buildings, the shear resistance of masonry shear walls...
Three-Dimensional Analysis Model for Complete Masonry Buildings
For the predictive and diagnostic analysis of the complete nonlinear response of masonry buildings to seismic load input, a 3-D finite element model is under development at UCSD. The model,...
Interactive Buckling Analysis of Stiffened Shells Using Pregnant Sheel Elements
Two distinctive modes of failure dominate the failure of stiffened plates and shells, viz. the short-wave local mode and the long-wave overall mode. A new finite element technique which...
Buckling of Cylindrical Storage Tanks Due to Unsymmetric Lateral Wind Load
Non-linear finite element analysis is used to study the elastic stability of cylindrical storage tanks subjected to unsymmetrical loads. These cylindrical shells are assumed to be fixed...
Finite Element Analysis of a Highway Bridge Hinge
A highway bridge hinge is a very important element in bridge design. It releases thermal stresses that may be developed in the superstructure or the substructure of a bridge. A common...
Return to search