Steel Girt Design
Procedures are presented for the design of light gage cold formed girts and hot rolled girts. The effects of continuity, sag rods, and wall sheeting are discussed. Design procedures are...
NDE for Performance of Wood Structures
Significant economic losses result annually due to deterioration and failure of structural wood components. A high percentage of these losses result from our current inability to assess...
Inelastic Response of Buried Pipelines Due to Landslide Effects
During earthquakes, a buried pipeline may experience significant loading as a result of large relative displacements of the ground along its length. Large ground movements can be caused...
Local Wind Pressures on Roofs
The paper reviews the results of the most recent research studies in the evaluation of wind pressure coefficients for the design of roof cladding elements. The effect of roof geometry...
Wind Effects on Loose-Laid Cladding Systems
Modern roofing systems for flat roofs frequently make use of rigid insulation boards, gravel and concrete pavers that are loose-laid on top of the waterproof membrane. The authors have...
Full-Scale Measurement on Chiba Port Tower
Chiba Port Tower is a tall tower, 125m high, with a rhombus shaped plan. All of the surfaces are covered with half mirror glass. On the top of the tower, a 'Tuned Mass Damper'...
Unsteady Aeroelastic Base Moments on a High-Rise Building
To consider aeroelastic instabilities of prismatic structures in winds, i.e., vortex induced vibrations or galloping oscillations, unsteady aeroelastic forces must be investigated as the...
Vibration-Induced Wind Pressure on Large Span Flat Roof
Vibration-induced wind pressures on a large span flat roof was investigated by a wind tunnel using a uniformly turbulent flow. Measurements of pressures were made on an asymmetrically...
A New Proposal of Design Wind Loads for Beams Supporting Long-Span Roofs
The wind tunnel testings of wind pressures acting on long-span roofs are carried out. Dynamic wind pressures are measured simultaneously at a lot of points on the roofs. The instantaneous...
Pressure Measuring System for Wind Loads
A project to acquire wind and building surface pressure data in the field is continuing at Texas Tech University. A test building of dimensions 30 ? 45 ? 13 ft (9.1 ? 13.7 ? 4.0 m) and...
Hydrodynamic Isolation of Concrete Dams
The feasibility of reducing hydrodynamic effects in the earthquake response of concrete dams by anchoring gas-filled balloons or injecting bubbles in the water is investigated. Significant...
Site Characterization of Yorktown Formation for New Accelerator
The design of a new 1700-m long continuous-wave electron beam accelerator facility (CEBAF) in Newport News, Virginia demanded an extensive geotechnical exploration program be conducted...
Pressuremeter Evaluation of Glacial Till Bearing Capacity in Toronto Canada
Glacial tills were evaluated at three Toronto sites, using conventional methods, the pressuremeter and full scale caisson load tests. The geologic environment and specific subsurface conditions...
Location of Geologic Discontinuities by Geophysical Techniques
An overview of the seismic refraction method and resistivity methods is given. These two geophysical techniques are integrated into a systematic method for locating geologic discontinuities...
Screw Plate Test for Drained and Undrained Soil Parameters
This paper describes a screw plate test device developed with a capability to measure the generation and dissipation of excess pore water pressure during testing in cohesive soils. The...
Some Dilatometer Test Results in Pennsylvania and New York
This paper starts with a brief introduction to the dilatometer and piezoblade. Test results in four different areas are presented. DMT soundings at LR 67057 (Legislative Route numbers...
Collapsible Soils in the Antelope Valley�California
Soils subject to hydroconsolidation, commonly referred to as collapsible soils, have a potential to undergo significant volume reductions upon wetting, with or without additional loading...
State-of-the-Practice Mitigation Measures for Collapsible Soil Sites
Mitigative alternatives for collapsible soil sites are reviewed considering shallow, as well as deep, collapsible soil deposits. In the case of deep soil deposits the overburden pressures...
Design Methodology for Foundations on Stone Columns
Stone columns offer the geotechnical engineer a valuable and viable technique for stabilizing sites underlain by soils ranging from soft clays to loose silty sands. A discussion of the...
Consolidation Grouting Operations for Kirkwood Penstock
Kirkwood Penstock, which is part of the Hetch Hetchy water system of the City of San Francisco, California exhibited evidence of settlement and local extension following extraordinarily...
Return to search