Type Curves for a Slug Test in an Infinitely or Semi-infinitely Thick Aquifer
Type curves are provided for a slug test in an infinitely or semi-infinitely thick aquifer, the latter with the single confining layer immediately above or immediately below the well....
Application of Decision Analysis in Groundwater Remediation Design
The design of groundwater remediation systems involves selecting from a set of design alternatives under conditions of uncertainty. A risk-based decision analysis approach is presented...
Aquifer Measurements at Different Scales
Multilevel slug test data from five wells in a confined, sandy aquifer were analyzed to obtain an estimate of the vertical variation of the horizontal hydraulic conductivity, K(z). Hydraulic...
Application of Tracer Tests in Groundwater Remediation Design
Recent advances in the area of field testing for the quantification of hydraulic conductivity have resulted in improved site characterization of aquifer hydraulics and greater reliability...
Buoyant, Miscible Plume in Heterogeneous Aquifer
A three-dimensional, particle tracking scheme is used to compute the trajectory of and spread about the centroid of a mass slug added to steady flow through an infinite aquifer with an...
Potential Effects of Global Climate Change on the Central and Southern Florida Project
The possible impacts of some potential climate change effects such as sea level rise, changes in tropical cyclone intensity and frequency, and changes in precipitation and temperature...
Sediment Transport Measurements in the Nile River at Bani Mazar
Measurements of sediment transport on the Nile River were conducted at Bani Mazar (200 km South of Cairo) during high and low water stages. Bed-load and suspended-load transport rates...
Movable-Bed Model to Evaluate Nile River Dredging
About 200 km south of Cario, at Bani Mazar reach, the Nile River has widened and formed several islands. The result is three channels with shallow depths. One of the branches must be improved...
Application of Stable Channel Design Method
Systematic stable channel design methods are currently being developed by the US Army Engineer Waterways Experiment Station for use in the planning stages of local flood control projects....
Hydraulic Aspects of Grade Control Structures
This paper describes the function of grade control structures. The primary purpose of a grade control structure is to maintain or establish a desired bed elevation in a channel. Basically...
Bed Load Roughness in Supercritical Flow
A supercritical concrete channel is proposed for Mission Creek located in Santa Barbara County, California. The proposed channel may transport gravels and cobbles as bed load during large...
Riprap Design Criteria for the ARS Low Drop Structure
The ARS low drop grade control structure has proven to be an effective means to stabilize incised channels in Mississippi. However, field inspections and laboratory testing have indicated...
New Lessons About the Hydraulic Performance of Highway Storm Sewer Inlets
Laboratory experiments were performed with highway storm water curb inlets to 1) reduce the oblique standing wave that extends into the highway from the downstream side of the inlet and...
Stepped Spillway Design for Flow Over Embankments
Many embankment dams have been identified as unable to pass their design flows without failure due to overtopping. The U.S. Bureau of Reclamation (Reclamation) is currently at the forefront...
Overtopping Flow Spillway for Baldhill Dam, Sheyenne River, North Dakota
An existing gated spillway structure for Baldhill Dam and Reservoir (Lake Ashtabula, North Dakota) is not capable of passing floods up to the probable maximum flood (PMF) without overtopping...
Fluidization Pipe Hole Spacing
Two-dimensional fluidization experiments are performed on fine (d50 = 0.15 mm) and medium coarse (d50 = 0.45...
Design of Groins on the Middle Rio Grande
The Albuquerque Projects Office of the Bureau of Reclamation wanted to use groins in place of revetments at two sites on the Rio Grande. The Bureau of Reclamation has limited experience...
Preventing Stilling Basin Abrasion
A 1:10 scale physical hydraulic model of Taylor Draw Dam outlet works was used to develop modifications to prevent back flow intake of rock into the stilling basin. Much of the back flow...
Hydraulic Features of Flexible Curtains Used for Selective Withdrawal
Flexible curtain barriers are being investigated as a way to modify power penstock intakes to achieve selective withdrawal. The curtain barrier controls the elevation from which water...
Modeling and Field Experiments for Tracer Gas Tests
Numerical modeling and field experiments were used to extend the tracer gas technique for determining surface gas transfer rates to shallow bays. Two-dimensional modeling was used to investigate...
Return to search