Cyclic Lateral Load Analysis of Composite Frames
A method of analysis for composite building frames subjected to repeated and reversed lateral loads has been developed as part of an overall investigation of seismic response of composite...
Seismic Performance and Composite Action of Older Structures
A study into the seismic performance of older steel structures is described. A review is made of the types of steel building construction completed during the period of interest, and the...
Connection of Beam Flange to Concrete-Filled Tubular Column
Research has been carried out on a frame composed of a concrete-filled steel tubular column and H-shaped steel beam with the aim of developing a reasonable connection method. The proposed...
Force Transfer in Composite Columns
The force transfer from steel to concrete without mechanical transfer devices in composite columns at points of load introduction is studied. A mechanism of force transfer and the factors...
Flow Study of In-Service Sanitary Sewers Rehabilitated with Insitupipe
In an effort to define the flow characteristics of sanitary sewer segments rehabilitated with Insituform under normal in-service conditions, Insituform of North America, Inc. (currently...
Pipeline Leak Detection Based on Mass Balance
Current technologies in Supervisory Control and Data Acquisition (SCADA) systems enable pipeline leak detection to be carried out in real time by software-based methods. This paper discusses...
Relocating a 54-Inch Diameter Force Main without Interrupting Wastewater Flow
The City of Tampa, Florida, was faced with the challenge of relocating three segments of an old 1372 mm (54-in.) diameter reinforced concrete pipe force main, totaling nearly a mile in...
Chemical Resistance of Thermosetting Resins Used for Cured-in-Place Pipe
This paper summarizes the chemistry, short term physical properties, and long term chemical resistance for representative epoxy vinyl ester, epoxy, and polyester resins that are currently...
Accessibility of Geotechnical Earthquake Engineering Data and the Need for Data Storage and Dissemination Standards
Ease of data access and data standards are two issues critical to the success of GIS technology when applied to earthquake hazards research problems that require geotechnical engineering...
Assessment and Repair of Fire-Damaged Concrete Structures
Concrete, even though it may be the most fire-resistant of all the major building materials, can be damaged by fire. Seldom does even a major fire cause total destruction, however, most...
Engineering Hydrology
This proceedings,
Hydraulic Engineering
This proceedings,
Seismic Design of Multi-Story, Wood-Framed Buildings
The seismic design and analysis of wood-framed structures is relatively simple; however, the challenges that present themselves within this design medium are shear and overturning force...
LRFD for Timber Structures
The use of load and resistance design (LRFD) methodologies is increasingly becoming the standard analysis procedure for engineering design. The concrete industry has used a variation of...
Structural Fire Resistance Design of Wood Beams and Columns: A Comparison of European and North American Practices
North American and Eurocode design methods for fire-resistive exposed wood members provide a very good example of the translation of research into practical engineering design procedures....
Drilled Shaft Side Resistance in Clay Soil to Rock
An evaluation is made of available field load test data for the axial side clay soils to hard rocks. Conventional total stress interpretations by the alpha method are used to examine the...
Side Resistance of Drilled Shafts in the Denver and Pierre Formations
Results of load tests on drilled shaft foundations in Upper Cretaceous shales are described and evaluated. Three load tests were conducted on shafts in the Denver Formation, in Denver,...
Behavior of Instrumented Model Piers in Manufactured Rock with a Soft Layer
A laboratory test apparatus has been used to study the side resistance of piers socketed into manufactured soft-rock masses. The results of four tests are reported, three of which included...
Permeability Determination for Unsaturated Soils
A reliable approach for the determination of the soil hydraulic conductivity function relies on the parameter estimation solution approach in which heterogeneous state of saturation within...
Transit Times Through Compacted Clay Liners
Transit time, or time taken by waste liquid to move through the thickness of the liner, is a short-term performance parameter which can be used to determine the necessary liner thickness....
Return to search