Flow Modeling in the Toutle River, Washington
In support of flow, suspended load, bed load, and bedform transport measurements, a quasi-three-dimensional river flow model was adapted to a reach extending from 260m upstream to 30m...
Alluvial Stream Bank Erosion?A 10-Year Study
Results of investigations of bank erosion along alluvial streams between 1977 and 1989 are given. Natural processes were found to dominate, with piping an important but hitherto unrecognized...
Criteria for a Sediment Data Set
The transport of sediment through a hydrologic system or basin is an extremely complex phenomenon. Many factors affect this movement. Criteria are established for an 'ultimate' or complete...
Field Data Collection and Analysis of Hyperconcentrations and Mud Flows
Hyperconcentrated flows and mud flows exhibit properties quite dissimilar from Newtonian fluids. In order to further our understanding of such phenomena, field data have been collected...
Total Sediment Discharge Measurement
A procedure for measuring total sediment discharge using point-source suspended-sediment data was developed. The procedure, Total Sediment Discharge (TSD), was compared to field and modified...
Sediment Yield and Mean Annual Discharge from Watersheds in the Indian Subcontinent
Measurements of sediment deposition in reservoirs located in the Indian subcontinent (India, Nepal, Pakistan) indicate that the rate of sedimentation is much higher than predicted during...
Surface Roughness with Erosion of Earth Channels
A determination of the stresses effective in soil detachment is essential in determining erodibility. The soil roughness that exists during testing and in natural channels is a key element...
Compendium of International Ocean Energy Activities
This
Electricity From Air
After a decade of research and dozens of feasibility studies at sites around the country, the first Compressed Air Energy Storage (CAES) plant in the U.S. is under construction at McIntosh,...
Local Scour at Bridge Abutments
Comparison of local scour depths at bridge abutments computed using different equations yields a large variation in predicted values. To consolidate the fragmented results of previous...
Investigation of Low-flow Phenomenon in Case of Droughts
By the use of streamflow and truncation levels, hydrologic droughts are defined. Flows of different truncation level are obtained from each selected subbasin. Flow ratio is calculated...
Sorting of Mixed Sand on a Two-Dimensional Beach
A numerical method is developed to predict temporal variations of the sea bed topography and the bed-material composition. The predicted results are compared with the measurements in a...
Determining River Stages with Consideration of Backwater Effects
In a recent hydraulic investigation on the Cache River basin, the stages of the Mississippi River at the Beechridge station were found to be necessary downstream boundary conditions for...
Bank Erosion: A Review of British Research
The paper summarizes recent contributions from British geomorphologists and hydrologists. This includes field measurements of processes, modeling of corrasion and mass failure, interactions...
Performance Characteristics of Compound Weirs
A theory is outlined which helps to explain the flow over compound weir under free overfall conditions. Experiments on twelve weirs of three sets with different dimensions are shown to...
Energy Dissipation Structure for Fixed-Cone Valves
Results of a model study to investigate the hydraulic performance of a proposed energy dissipation structure for fixed-cone valves are presented. Procedures for estimating pressures and...
Underwater Tunnel Inspection by Virginia Power Using a Submersible Robot
The Bath County Pumped Storage Station, has three large tunnels linking the upper and lower reservoirs. The 'Hydrover' submersible remotely operated vehicle (ROV)...
The Development and Writing of the ASCE/EPRI Hydroelectric Guidelines
In the Spring of 1989, the American Society of Civil Engineers (ASCE) and the Electric Power Research Institute (EPRI) jointly published their Civil Engineering Guidelines for Planning...
Important Aspects of Annual Energy Calculation Techniques for Low Head Hydro Power Plants
Annual energy calculations are frequently used to optimize design parameters at a turbine site and to compare energy production based on equipment offers from various suppliers. In this...
Quantifying Uncertainty in Hydropower Planning
Power system operators must deal with various types of uncertainties. Some are related to inputs, such as system load and water supply, while others pertain to the system itself, such...
Return to search