Local Scour Measurements at Bridge Piers in Alberta
A summary of local pier scour data collected by Alberta Transportation and Utilities (AT & U) over the past 30 years is presented. Several methods used to gather this data are...
Reference Surfaces for Bridge Scour Depths
Depth of scour is measured as the vertical distance between scoured channel geometry and a measurement reference surface. A scour depth measurement can have a wide range depending on the...
Uncertainty of Bridge Scour Estimates
Pier scour is the erosion of a streambed in the vicinity of bridge pier foundations. In this paper, fuzzy regression is used to develop two pier scour models, one based on crisp laboratory...
Field Examination of a Distribution System Water Quality Model
In the aftermath of the Safe Drinking Water Act (SDWA) of 1974, numerous models have been established to assess the quality of water and simulate its deterioration in distribution systems....
Evaluation of Historical Scour at Selected Stream Crossings in Indiana
Geophysical data were collected by means of ground-penetrating radar and tuned transducer systems to estimate the historical scour at ten bridges in Indiana. These geophysical data were...
Shale Scour at BNRR Yellowstone River Bridge, MT
Both the Burlington Northern Railroad and Montana Department of Transportation bridges across the Yellowstone river just south of Laurel, Montana, are founded on spread footings placed...
Analysis of Local Scour at Bridge Piers
Many studies have been performed on the cause and effects of local scour at bridge piers, and various prediction equations have been generated based on these studies. The general approach...
New Canadian Provisions Related to the Design of Composite Beams
In this paper, the new provisions in CAN/CSA-S16.1-M89 for the design of composite beams, together with reasons for changes, are discussed. Some of the new provisions reflect results of...
Two Full-Scale Tests of Class 3 Composite Beams
This paper presents two tests of continuous composite beams comprising two 7.5 m spans and two concentrated loads close to the intermediate support. Although the cross-sections on the...
Shear Connection in Composite Beams
This paper considers the influence of the shape of the deck profile on the shear connection of composite beams. It was found that the existing strength reduction factor can be unconservative...
Modern Design Concept for Composite Slabs with Ductile Behaviour
Numerous tests with different types of composite slabs have been carried out in the laboratory for constructional engineering of the University of Kaiserslautern, Germany in order to determine...
Design of Shear Connectors in Composite Bridge Beams
A new approach is described for the design of stud shear connectors, in composite steel and concrete beams that are subjected to vehicular loads, which allows for the interaction between...
Design of Composite Slabs for Vertical Shear
Three major modes of failure should be considered in the design of the positive moment regions of composite slabs incorporating profiled steel sheeting, viz.: flexure, longitudinal slip...
Seismic Performance and Composite Action of Older Structures
A study into the seismic performance of older steel structures is described. A review is made of the types of steel building construction completed during the period of interest, and the...
Development of Composite Slab with Truss-Typed Shear Connectors
This paper describes the results of the test on a steel-concrete composite slab with truss-typed shear connectors. This composite slab was recently developed. A series of tests were conducted...
Composite Columns Subjected to Bending and Shear
This paper describes experimental as well as analytical studies of the post elastic deformation and fracture behaviors of wide flange steel encased reinforced concrete (SRC) composite...
Full-scale Tests on Composite Connections
Tests have been carried out on eight full-scale composite connections in which the columns were manufactured of concrete-filled steel circular hollow sections (CHS). The connections were...
Steel Beams with Reinforced Concrete Stiffened Ends
For the construction of office building with long span beams, steel beams with reinforced concrete stiffened ends are being used in order to increase the stiffness. This paper describes...
Behavior of Concrete-Filled Steel Tubular Three-Dimensional Subassemblages
Three-dimensional subassemblages consisting of a concrete-filled steel tubular column and four H-shaped beams were tested under a constant axial load on the column, constant beam loads...
Influence on Steel Deck on Composite Beam Strength
Results of a recent study were described in which 7 push-out tests and 4 composite beam tests were conducted. The results were consistent with other recent studies reported in the literature,...
Return to search