Development of a Self-Heating Thermal Probe for Saline Permafrost
Geothermal modelling and prototype testing are described to support the development of a self-heating thermal probe. This has application for in-situ determination of the amount of unfrozen...
Installation of Thermistor Strings in Test Borings: A Comparison of Methods and Results
Several test borings were instrumented with two thermistor strings, one inside and one outside an air-filled PVC casing to compare readings of both thermistor strings and the stability...
Monitoring Techniques for Thermosyphons
Two-phase thermosyphons used for passive soil refrigeration are monitored using a variety of techniques ranging from visual infrared scanning to measurement of internal pressures. Methods...
Arctic Stream Scour: A Case History
A small arctic stream on the North Slope of Alaska was monitored through one hydrologic cycle. The flow rate of the stream and the progress of its erosion through a breach into an adjacent...
Effluent Dispersion Measurements Under Sea Ice
Field measurements of the dispersion of effluent from the Seawater Treatment Plant (STP) at Prudhoe Bay, Alaska, were made during April 1985. The primary objective was to determine whether...
Predictions of Thermally Induced Stresses in Thin Walled Grain Storage Bins Under Declining Ambient Temperatures
A generalized constitutive equation for cohesionless sands based on elasto-plastic theories is applied to a grain bin system. The validity of the theory is established through the finite...
Evaluation of Building Response Recorded During the Morgan Hill Earthquake
On April 24, 1984, the Morgan Hill Earthquake (Richter magnitude 6. 2) occurred within approximately 15 km of IBM Corporation's computer-equipment manufacturing facility located...
A Critical Look at Building Instrumentation in Earthquake Engineering
This paper discusses different issues and requirements existing in the area of building instrumentation. Strategies and types of equipment currently being used by the United States Geological...
Some Experimental Results on the Dynamic Behaviour of a 40m Guyed Mast
This paper presents the first results and elaborations obtained from the tests of an experimental 40m tall guyed mast. The instruments installed to date are a cup anemometer on the mast...
Changes in Bridge Deck Flutter Derivatives Caused by Turbulence
This paper discusses some of the results of a wind tunnel study that tested the aeroelastic stability of section models in smooth and gusting flow. Wind gusts several times longer than...
Pressuremeter and Shallow Foundations on Sand
The settlement and bearing capacity rules for the design of shallow foundations on sands using the results of pressuremeter tests are reviewed. The results of four footing tests to failure...
Design Concepts for Floating Breakwaters
This paper describes a fundamental approach to the design of a floating breakwater based on the concepts of dynamic analysis of floating bodies. The process results in a relatively simple...
Plugging into a Dam
Instruments are embedded into hundreds to dams around the world. But for instrumentation to be effective, the instruments must be read, and the data must be plotted and compared to predicted...
CAD Mapping Trailblazer
Until three years ago, few civil/surveying firms had automated both surveying (including digital recording of angles and distances shot in the field) and the related design and drafting....
Deformation Characteristics of Cohesionless Soils from In Situ Tests
This paper is a summary of seven years experience gained by the National Electricity Board of Italy (ENEL), ISMES and Technological University of Turin in assessing these parameters using...
Pressuremeter and Foundation Design
The design of shallow and deep foundations on the basis of pressuremeter results is analyzed using numerous load tests and case histories. The foundations are shallow footings subjected...
Field Permeability Test for Earthen Liners
A sealed double-ring infiltrometer (SDRI) was developed for in-situ measurements of the hydraulic conductivity of earthen liners and covers. The characteristic of the SDRI that distinguishes...
Pressuremeter Correlations for Preconsolidated Clay
Conventional triaxial compression and consolidation tests are often utilized to obtain parameters for design of foundations. More recently, Menard pressuremeter test results have been...
Predictions of Pile Shaft Capacity With the PLS Cell
In situ measurements of stresses and pore pressures on a model pile shaft, the Piezo-Lateral Stress (PLS) cell, are utilized to reconstruct the conditions of load tests involving two large...
Flat Dilatometer Tests in Calibration Chambers
This paper presents the results of a series of Flat Marchetti's Dilatometer Tests (DMT's) performed in a large Calibration Chamber (CC) on dry Ticino (TS) and...
Return to search