Inelastic Seismic Analysis of Concrete Buildings
The important inelastic analysis techniques that are suitable for concrete buildings subjected to earthquakes are summarized. Basic principles and practical modeling guidelines are given...
Bermed Shelters Subjected to Accidental Explosions
An investigation of the adequacy of two competing shelter designs to protect the occupants from an accidental explosion in a nearby shelter is described. Two bermed shelters, one of rectangular...
Residual Capacity of Explosively Damaged Reinforced Concrete Columns
The results of load tests on explosively damaged reinforced concrete columns are presented. The method used to correlate an ultimate strength, laminar type of reinforced concrete analysis...
Structural Resistance of Slabs for Blast Loading
Results from a series of static tests on one-way reinforced concrete slabs are summarized. The slabs were loaded with a uniform pressure and tested to large deflections. Parameters varied...
Reevaluation of Reinforced Concrete Slabs Subjected to Blast Effects
Failures in reinforced concrete shallow-buried structures subjected to the effects of severe dynamic loads are reevaluated by employing a modified Timoshenko beam formulation which includes...
Site Characterization of Yorktown Formation for New Accelerator
The design of a new 1700-m long continuous-wave electron beam accelerator facility (CEBAF) in Newport News, Virginia demanded an extensive geotechnical exploration program be conducted...
Pressuremeter Evaluation of Glacial Till Bearing Capacity in Toronto Canada
Glacial tills were evaluated at three Toronto sites, using conventional methods, the pressuremeter and full scale caisson load tests. The geologic environment and specific subsurface conditions...
Screw Plate Test for Drained and Undrained Soil Parameters
This paper describes a screw plate test device developed with a capability to measure the generation and dissipation of excess pore water pressure during testing in cohesive soils. The...
Some Dilatometer Test Results in Pennsylvania and New York
This paper starts with a brief introduction to the dilatometer and piezoblade. Test results in four different areas are presented. DMT soundings at LR 67057 (Legislative Route numbers...
Collapsible Soils in the Antelope Valley�California
Soils subject to hydroconsolidation, commonly referred to as collapsible soils, have a potential to undergo significant volume reductions upon wetting, with or without additional loading...
State-of-the-Practice Mitigation Measures for Collapsible Soil Sites
Mitigative alternatives for collapsible soil sites are reviewed considering shallow, as well as deep, collapsible soil deposits. In the case of deep soil deposits the overburden pressures...
Design Methodology for Foundations on Stone Columns
Stone columns offer the geotechnical engineer a valuable and viable technique for stabilizing sites underlain by soils ranging from soft clays to loose silty sands. A discussion of the...
Consolidation Grouting Operations for Kirkwood Penstock
Kirkwood Penstock, which is part of the Hetch Hetchy water system of the City of San Francisco, California exhibited evidence of settlement and local extension following extraordinarily...
Modelling of Displacement Piles in Sand Using a Pressure Chamber
This paper describes a method of modelling the driving and loading of piles in the laboratory that permits variations of significant parameters and maintains effective stresses at levels...
Transient Dynamic Response Analysis of Embedded Rigid Foundations
A simplified approach for the transient dynamic response analysis of embedded multiple rigid foundations is presented. The approach is based on approximate time-domain formulations of...
Subgrade Model for Static and Dynamic Response Analysis of Surface Foundations
A new subgrade model is presented for the static and dynamic response analysis of surface foundations. The model consists of a number of horizontal layer model units. Each model unit is...
Foundation Studied for Turbine-Generator on Liquefiable Soils
Turbine-generator foundations are generally constructed of concrete in the U.S.A. This paper deals with the dimensioning and evaluation of a turbine foundation in Oxnard, California. The...
Seismic Response Considerations in Foundation Design
There are no generally accepted procedures to determine the potential magnitude of reduction of footing bearing capacity that may result from soil strains or pore pressure changes during...
Bearing Pressure?SPT Correlations for Expanded Base Piles in Sand
Design of enlarged base piles is usually carried out using correlations between SPT N values and point resistance. The results of full scale load tests are used to show that base resistance...
Performance of Different Retention Systems in Similar Soils
Performance behaviour of three deep braced excavations in a similar soil profile, in the Chicago area is described. At each site, different bracing systems were utilized. Methods used...
Return to search