Drifted Snow on Roofs
Drift snow loads on multilevel roofs account for about 75 percent of all snow load related roof collapses. A case history of snow drifts provides the foundation for a discussion of the...
New Support for Pin-Hanger Bridges
To promote safety of their bridges, many state highway departments are considering ways to add auxiliary support to existing pin-hanger bridges. The Pennsylvania DOT and its open-end consultant...
Design of Large Capacity Coal Silos for Service Life
Design and construction of Large Capacity Coal Silos for service life requires a careful consideration of the silo configuration as well as the material handling system. This paper presents...
Improved Corrosion Protection for Flue Gas Systems Utilizing a Dual Liner Concept
A unique system of corrosion resistant materials has shown excellent performance and durability in flue gas systems for fossil plants, cogeneration plants, waste incinerators and waste-to-energy...
Will The Market in Emission Allowances Work?
The Clean Air Act Amendments of 1990 introduce a major new control program to mitigate the impacts of acid rain. The control program, which has been under debate for approximately a decade,...
Projections for Reduction in Lake Acidification From SO2 Emission Reductions
The Acid Deposition Assessment Model (ADAM) is used to assess the possible range of effects of a national acid rain emission reduction plan on lake chemistry and fish populations in the...
Evaluating Advanced Technologies for Acid Rain Compliance
Technological innovation in emissions control of acid rain precursors has made possible increasingly stringent control requirements for coal-fired power plants. A key challenge for potential...
Optimization Models for Acid Rain Control
A series of related optimization formulations are presented for developing and analyzing acid rain control strategies. These models span a wide array of approaches and reflect a similarly...
Containment Capacity and Failure Modes Beyond Design Basis Conditions
Analytical and experimental studies have shown that containments can at least sustain two to three times design pressures. Under the severe accident overpressure loading, experimental...
Wind Frame Design for Mid Rise Buildings
A brief discussion of drift limits is followed by design procedures for unbraced moment resisting wind frames and initial selection of optimized member sizes for chevron bracing frames....
Approximate Preliminary Methods for Design of Lateral Load Resisting Systems in High Rise Buildings
A new group of optimization programs uses the speed and power of modern computers to eliminate the need for guessing preliminary sizes. Starting with any arbitrary sizes and a fixed geometry,...
High-Capacity, High-Strength Trailer Designs for the GA-4/GA-9 Casks
General Atomics (GA) is developing final designs for two dedicated legal-weight trailers to transport the GA-4 and GA-9 Spent-Fuel Casks. The basic designs for these high-capacity, high-strength...
Multiple Event Considerations for Postclosure Seismic Hazard Evaluations at Yucca Mountain, Nevada
Postclosure waste canister design requirements suggest the values used for seismic design have less than a 10% chance of being exceeded in a 1,000 year postclosure period. Considerably...
Predicted Thermal and Stress Environments in the Vicinity of Repository Openings
An understanding of the thermal and stress environment in the vicinity of repository openings is important for preclosure performance considerations and worker health and safety considerations...
Field Investigations for Seismic Effects on Mechanical and Geohydrologic Response of Underground Structures in Jointed Rock
An exploratory Seismic Rock Mechanics research program has been initiated by the U.S. Nuclear Regulatory Commission at the Center for Nuclear Waste Regulatory Analyses (CNWRA) to study...
Regulatory Requirements and Long-Term Repository Host Rock Performance
The regulatory requirements governing the disposal of high-level radioactive wastes in mined geologic repositories acknowledge the long-lived nature of the wastes and require the consideration...
Potential Uses of Lead in Nuclear Waste Disposal
In order for lead to be considered as a nuclear waste packaging material, it must be shown that it has adequate corrosion resistance, and that it does not degrade the properties of other...
GA-4/GA-9 Honeycomb Impact Limiter Tests and Analytical Model
General Atomics (GA) has a test program underway to obtain data on the behavior of a honeycomb impact limiter. The program includes testing of small samples to obtain basic information,...
Modelling of Excavation, Thermal Loading and Bentonite Swelling Pressure for a Waste Repository
For the performance assessment of a future nuclear waste repository, the excavation of the tunnel and deposition hole, thermal loading from waste heat release and the swelling pressure...
The Radiological Capacity of Transport Casks Loaded in a 2-Region Non-Uniform Pattern
The radiological capacity of spent fuel storage and transport casks can be increased by the use of non-uniform cask loading. There are many possible combinations of spent fuel burnup and...
Return to search