Creep Rate Analysis of Pile Load Test Data
The uniform creep behavior of five driven piles and one slurried pile based on pile load test data are presented and analyzed. The incremental static load tests carried out by ARCO, Alaska...
Research Challenges in Frozen Ground Pile Design
A fairly recent pile design analysis is reviewed. The influence of such factors as temperature, salinity, loading, etc. on frozen ground pile design is pointed out. Since many facets of...
Earth Pressure on Underground Concrete Pipe in a Field Test
The cause of cracking at the sheetpile extraction in concrete pipes buried by the open excavation method was investigated by loading tests on the pipe and a field test carried out by Osaka...
Earth Pressure on Underground Rigid Pipe in a Centrifuge
A series of centrifugal model tests on underground pipes that simulate the actual construction process were carried out to investigate the earth pressure concentration onto the pipe (particularly...
Maintaining a Natural Gas Pipeline in Active Landslides
This paper deals with a pipeline section on both sides of Douglas Pass in west Colorado. Landslide activity in the area has been causing considerable problems and disruptions of the pipe...
Seismic Pope Support Construction Practices
During the mid 1970's the regulatory agencies controlling the design and construction of nuclear power plants began to demand stricter adherence to already existing codes...
Structural Retrofit for Nuclear Power Plants
Retrofitting of nuclear power plants is a major concern these days. Recent rulings of regulatory agencies have affected most of the generating plants in some way. The lessons learned from...
Modifying Piping Systems During a Plant Outage
This paper describes methods to reduce problems in design and planning of modifications to piping systems during a nuclear plant outage. Significant differences between original design...
Evaluation of Structures by Dynamic Load Testing
The Frequency Sweep Method for the evaluation of structures by dynamic load testing was developed by the senior author. It is a non-destructive testing (NDT) method that was originally...
Standards for Pile Load Tests in Permafrost
A requirement exists to establish standard procedures for conducting pile load tests in permanently frozen soils. The methods outlined in the ASTM Standards for piles in thawed soils do...
Attenuating Creep of Piles in Frozen Soils
Results of several long-term creep tests of piles in frozen soils are analyzed; the primary or attenuating creep is predominant in most cases. For effective design of pile foundations...
Snow Effects on Pile Design Temperatures
The construction of North Slope aboveground pipelines and gathering lines is generally from snow workpads constructed proximate to existing access roadways. The pile support centerline...
Geotechnical Behavior of Underreams in Pleistocene Clay
Enlarged bases are often constructed in cylindrical drilled-and-cast-in-situ foundation elements (footings, bored piles) to increase their capacity. Enlarged bases that are cut mechanically...
Review of Repeated Axial Load Tests on Deep Foundations
A review of the literature is presented on the axial capacity of deep foundations subjected to repeated loads. Data are summarized on anchors, driven piles, and drilled shafts. In general,...
Filters and Leakage Control in Embankment Dams
In the practice of earth dam engineering there has been some doubt that downstream filters could be relied upon completely to control and seal concentrated leaks through impervious dam...
Earth Dam Seepage Control, SCS Experience
The U. S. Department of Agriculture's Soil Conservation Service (SCS) designs and administers construction of a large number of small- or medium-sized dams. SCS experience...
Containment of Textile Waste Using a Geomembrane
A wastewater treatment plant for a textile mill incorporated two 2. 7 million gallon aeration ponds which had originally been lined with clay. The clay liner leaked and caused the formation...
Incorporating Graphics in Water Distribution Analysis
One area that has currently been receiving attention is the presentation of hydraulic analysis results utilizing computer graphics to display pipe network and pressure values in graphical...
Adapting a Pipe Network Analysis Computer Program
The Metropolitan Water District of Southern California (Metropolitan) has developed a mathematical simulation model for a key portion of its distribution system. A representative portion...
State-of-the-Art Pipe Network Optimization
Within the next decade water distribution system optimization models should become everyday tools of practicing engineers. This paper examines existing models and discusses some of the...
Return to search