Model Studies for Potential Modification of Pardee Spillway
East Bay Municipal Utility District, a public water supply agency in the San Francisco Bay Area, is examining the spillway adequacy of its primary water supply reservoir. Flood routing...
Fretting Corrosion on Large Split Thrust Bearing Runners
In the early fifties interfacial slip was measured on laboratory models. Design improvements, resulting from these tests, were incorporated into later machines. These improvements appreciably...
Roller Compacted Concrete Dams?An Overview
The development of roller compacted concrete for gravity dams is traced from forerunners, through its use at the Shihmen and Tarbela Dam Projects to Willow Creek Dam and the Japanese Roller...
Cedar Falls Roller Compacted Concrete Dam
This paper presents the design, material testing, quality control, and construction considerations applicable to a small Roller Compacted Concrete (RCC) dam. The Cedar Falls RCC dam is...
Compaction Characteristics of Roller Compacted Concrete
This paper describes a fundamental study on the compaction characteristics of Roller Compacted Concrete (RCC) in the fresh state during vibration through a laboratory test and a field...
Comparison of Joint Shear Strengths for Conventional and Roller Compacted Concrete
Direct shear test data for parent material and bonded and unbonded jointed specimens of conventional and RCC (roller compacted concrete) are presented and compared. Results are discussed...
Roller Compacted Concrete Mix Design for Pamo Dam
Pamo Dam is designed as a 265 foot (81M) high gravity dam that will be located on the Santa Isabel Creek in San Diego County, California. RCC volume will be approximately 491,000 cubic...
Evaluation of Cores From Two RCC Gravity Dams
Galesville Dam, Oregon, completed in August 1985, and Upper Stillwater Dam, Utah, completed in August 1987, are two RCC (roller compacted concrete) gravity dams featuring different approaches...
Construction of Elk Creek Dam
Construction of Elk Creek Dam, located in Southwest Oregon, is currently underway with completion scheduled for September 1988. The main dam contract was awarded to Ohbayashi Gumi Ltd....
Whither Roller Compacted Concrete for Dam Construction?
During the formative years of the roller compacted concrete (RCC) dam, three different approaches to the design have evolved; the lean RCC dam, the RCD (rolled-concrete dam) method and...
Roller Compacted Concrete Design for Urugua-I Dam
Gravity dam construction by the roller compacted concrete method (RCC) has received widespread interest following completion of Shimajigawa Dam in Japan (1981) and Willow Creek Dam in...
A Stochastic Seismological Model in Earthquake Engineering
Recent studies of source mechanisms and wave propagation models enable one to generate strong motions based on deterministic source and source-to-site characteristics. The normal mode...
Autoregressive Model of Spatially Propagating Earthquake Ground Motion
An autoregressive random process model was used to investigate a simulation method of spatially and temporally variative ground motion when characteristics of motion are prescribed by...
Effect of Air Gap on Platform Reliability
A simplified reliability study of the effect of lateral wave forces impacting the deck of a fixed platform is presented. The reliability of the deck legs, considered the primary resistance...
Small Diameter Gravity and Pressure Sewers
In communities with low population density or physical features that make conventional gravity sewers inordinately expensive, alternative sewer technologies can be significantly lower...
Towards a Better Simulation of Sea States for Modelling of Coastal Structures
In the last fifteen years, techniques of wave generation have advanced to such an extent that it is now possible to exercise controls of parameters such as wave grouping, wave asymmetries,...
Reef Breakwater Response to Wave Attack
A method of predicting stability of a class of low-crested rubble mounds referred to as reef breakwaters is presented. Findings are based on a study which included an extensive series...
Rock Armouring to Unconventional Breakwaters: The Design Implications for Rock Durability
This paper identifies the need for quantitative durability testing of rock for use on dynamically stable rock armored slopes. The derivation and use of a suite of engineering tests for...
Reshaping Breakwaters on the Stability of Roundheads and Trunk Erosion in Oblique Waves
The stability of a berm type breakwater (sacrificial breakwater) was tested in a 3-dimensional model at The Hydraulics laboratory, Department of Civil Engineering, University of Aalborg....
Hydraulic Performance of Berm Breakwaters
In recent years, the concept of unconventional rubble mound breakwaters, i.e berm breakwaters, has gained much attention among researchers and engineers as an economical method to build...
Return to search