U.S. / Japan Large Scale Cooperative Research Program for Steel Structures
The US/Japan Cooperative Research Program Utilizing Large Scale Test Facilities for Earthquake Resistant Design was initiated in 1980 using a combination of full-scale, small-scale, subassemblage...
Impediments to the Implementation of Seismic Isolation
There are over 400 civil engineering structures, worldwide, that have been constructed using the principles of seismic isolation, and 70 of these are in the United States. Although use...
First Bank Place: A Composite Cruciform Spine
The First Bank Place, designed by the internationally known architectural firm of Pei Cobb Freed and Partners, is a granite-clad, 56 stories tall building in downtown Minneapolis. Presented...
One Peachtree Center: Atlanta Georgia
Presented in this paper are the architectural and structural concepts of One Peachtree Center built in the city of Atlanta. This 62-story tall building has changed the downtown skyline...
One Ninety One Peachtree and NationsBank: Composite Additions to the Atlanta Skyline
The structural design of two composite buildings in Atlanta is described in this paper. A composite exterior partial tube was used in one case and a composite super-column system was utilized...
Marta North Line Midtown Station
This paper presents a case study of a cast-in-place concrete rapid transit station structure. Attention is focused on the performance of the monolithically connected, three-dimensional...
Talmadge Bridge Replacement
This paper discusses the design of the main spans and approach spans for the replacement of the Talmadge Bridge for the Georgia Department of Transportation. The design of the concrete...
Making an Olympic Stadium and a Baseball Park
A new dual-purpose stadium which reflects not only the classical origins of the Olympic Games, but also the tradition of baseball, is the architectural centerpiece for the 1996 Centennial...
Case Study - Performance of Diaphragm Walls During Construction; Predictions vs. Field Measurements
Rigid diaphragm walls (slurry walls) are being used more than any other earth supporting system for underground construction projects in confined downtown sites throughout the United States...
Overweight Trucks and Safety of Bridges
Most states face increasing pressure to issue more and heavier overweight truck permits. Current permit checking methods of many states adopt the AASHTO rating concept with or without...
Towards Structural Strength and Safety Evaluation Within Bridge Management Systems
Bridge management systems being implemented by transportation departments in the United States are limited in their ability to consider structural strength and safety when preparing recommendations...
Historical Considerations for New Jersey Viaduct
An Historical Bridge Alternatives Analysis report prepared for New Jersey Department of Transportation (NJDOT) for Route 1&9 S.B. viaduct in Newark, New Jersey evaluated the options...
Lateral Buckling: A Comparison of AISC-LRFD and Eurocode 3
The nominal moment capacity of laterally unsupported, doubly-symmetric, steel I-beams are computed and compared using the AISC-LRFD and EC 3 design recommendations. A review of the EC...
Seismic Performance of Railway Bridges
Historically, the seismic performance of railway bridges in the U.S.A. has been very satisfactory during earthquakes of this century. There are many possible factors contributing to this...
Seismic Research Program for Highway Construction
This paper provides an overview of the highway research program being conducted by the National Center for Earthquake Engineering Research (NCEER). This six-year program, which is sponsored...
Seismic Study of Historic Bridges in Eastern United States
The main objective of this paper is to study the Barrackville bridge and its response in resisting static and seismic loads. Since the design was based on controlled deflections, the analyses...
Moment-Rotation Behavior of Pultruded Beam-to-Column Connections
Presented are experimental details and results of five tests carried out to study the moment-rotation behavior of flange cleated connections for frames of pultruded members. The full-sized...
Averaging Time and Maximum Speeds in Hurricanes
This paper discuses wind speed data obtained during Hurricane Andrew around Miami International Airport, at six anemometer locations which make up the wind shear warning network. Data...
The Canadian Approach in the Design of Wood Structures: Conversion to Limit States Design
During the early 70's, the National Building Code of Canada (NBCC) established the principle that structural design be carried out using the limit states design (LSD) method. The technical...
Evaluation of Wood Floor Vibration Design Criteria
In the United States, floors in wood buildings are designed according to strength and deflection criteria under static uniform loads. With the introduction of engineered joist products...
Return to search