Decision Analysis of Coal Ash Disposal Technology
Coal-fired power plants produce a number of solid waste streams in the course of their operation. These coal combustion by-products (CCBPs) are composed of fly ash, bottom ash and boiler...
Scour and Fill Monitoring at Lock and Dam No. 26 (Replacement), Mississippi River
Information gathered during construction of the first stage dam is presented. The information consists of data indicating flows and stages along with data obtained from surveys which monitor...
RCC Dam Incorporates Innovative Hydraulic Features
An overview of the features of Monksville Dam is presented, with emphasis on the hydraulic components of the project. This 150-foot (45-meter) high roller compacted concrete structure...
Overtopping of Flood Control Levees and Floodwalls
The risk of overtopping can be significant for flood control levees or floodwalls, and the consequences can be costly and potentially catastrophic. Designs using superiority can force...
Numerical Flood Routing for Natural Channels
A numerical model has been developed for simulating the propagation of a flood wave in a natural channel. Using this numerical model, the influence of the factors affecting the motion...
Numerical Modeling of Flow in Hydropower Intakes
To reduce high mortality of downstream migrating juvenile salmon at hydraulic turbines, traveling screens are used to guide the juveniles into a bypass channel for safe passage. However,...
Water and Sediment Movement in Irrigation Furrows
Water movement in an irrigation furrow is simulated by numerically solving the governing equations of continuity and momentum for unsteady, spacially varied flow in a pervious bed open...
Hydraulic Testing of a Large Make-Up Pipeline
A 37 mile pipeline which consists of sections of 114 inch, 96 inch and 66 inch pipes was constructed for delivering secondary sewage effluents for power plant makeup. During initial operations,...
Coping with High and Low Pressures of Transient Flow
Conditions exist in most long distance water pipelines, such that abnormal but inevitable occurrences will cause transient flow. Often the most crucial conditions for consideration by...
Hydraulic Analysis of Water Transmission Flowing Party Full
The hydraulic behavior of a transmission line that flows full along only part of its length is more difficult to analyze than a completely full line. Unsteady open-channel and closed-conduit...
Stability of Method of Characteristics
For the analysis of waterhammer, the first-order accurate method of characteristics (MOC) has been widely used for which Courant condition for stability has been developed neglecting the...
Computer Aided Hydraulic Design of Pipelines
General purpose computer software packages are being used more frequently in the hydraulic design of pipeline systems. The areas where the use of such packages are advantageous over earlier...
The Design and Construction of the Bartletts Ferry Labyrinth Weir Spillway
The discharge capacity of the Bartletts Ferry Project has been increased 165 percent by the addition of a labyrinth weir spillway. The hydraulic design was based on a published design...
Valuable Design Insights Derived from Construction and Operation of Kinzua Dam
A number of design alternatives have surfaced during more than 17 years of operating experience at Kinzua Dam which should be useful in the design, construction, and operation of other...
A Nebraska Power District's Experience in Stabilizing by Silt Injection
The structures, rolled earth and concrete, of the Central Nebraska Project are constructed on foundations of loessial soils that range from a few feet to more than 100 feet in depth. The...
Intake-Shoaling and Pump-Vibration Problems
Iowa Generation's Council Bluffs Unit 3 circulating water-intake structure has experienced two major problems: (1) formation of sand bars in front of the trash racks during...
Operating Experience--Fine-Mesh Traveling Screens
Start-up and operating results for a new screenhouse at the Prairie Island Nuclear Generating Plant, 50 miles (80 km) downstream from Minneapolis/St. Paul, are compared to design assumptions....
Passive-Intake System for a Shallow Sand-Bed River
The Jeffrey Energy Center draws its cooling water make-up from the Kansas River near Belvue, Kansas. At this site, the Kansas River is a shallow sand-bed river of constantly changing bottom...
Japanese Experience with Intake Designs
To diversify its power sources, Japan has operating or under construction some 37 nuclear power units. This technology and the design criteria are imported from the U. S. The power plants...
Design of Selective Withdrawal Intake Structures
An overview is presented of the general methodology used by the U. S. Army Corps of Engineers in the design of selective withdrawal intake structures. Considered are the types of structures...
Return to search