Deformation Characteristics of Cohesionless Soils from In Situ Tests
This paper is a summary of seven years experience gained by the National Electricity Board of Italy (ENEL), ISMES and Technological University of Turin in assessing these parameters using...
Pressuremeter and Foundation Design
The design of shallow and deep foundations on the basis of pressuremeter results is analyzed using numerous load tests and case histories. The foundations are shallow footings subjected...
Field Permeability Test for Earthen Liners
A sealed double-ring infiltrometer (SDRI) was developed for in-situ measurements of the hydraulic conductivity of earthen liners and covers. The characteristic of the SDRI that distinguishes...
Pressuremeter Correlations for Preconsolidated Clay
Conventional triaxial compression and consolidation tests are often utilized to obtain parameters for design of foundations. More recently, Menard pressuremeter test results have been...
Predictions of Pile Shaft Capacity With the PLS Cell
In situ measurements of stresses and pore pressures on a model pile shaft, the Piezo-Lateral Stress (PLS) cell, are utilized to reconstruct the conditions of load tests involving two large...
Flat Dilatometer Tests in Calibration Chambers
This paper presents the results of a series of Flat Marchetti's Dilatometer Tests (DMT's) performed in a large Calibration Chamber (CC) on dry Ticino (TS) and...
Residual Soil Settlement From Pressuremeter Moduli
The Menard pressuremeter test is briefly described, and practical drilling techniques are summarized for Piedmont residual soils. Applications and limitations of the pressuremeter are...
Landslide Investigations Using the Weight Penetrometer
The weight penetrometer is a light weight device and can be easily deployed on slopes not accessible to conventional exploratory tools such as drill rigs or cone penetrometers. The weight...
Waterfront Electric Cone Penetration Testing
Offshore deployment methods developed for use by the oil industry were combined with less expensive nearshore drill barge technology. This resulted in the successful completion of cone...
Dilatometer Tests for the Design of Grouted Piles in Rock
A case study of drilled and grouted piles in rock, which were analyzed using results of down-hole dilatometer tests is presented. The tests were performed from a jack-up platform in water...
Pressuremeter Tests and Shoring Wall Design
Pressuremeter testing was used as an integral part in the design of the temporary tieback shoring wall for the Columbia Center office building in Seattle, Washington. Pressuremeter testing...
Dilatometer Tests in Sand
The paper presents two applications of the dilatometer test in sands: control of compaction and determination of constrained modulus. Twelve dilatometer tests were carried out before and...
Laboratory and Field Evaluation of Cone Penetrometers
Cone penetrometers from 8 organizations have been studied by performing laboratory tests and field tests. The testing show that pore pressure and temperature zero shift affect significantly...
The DMT - ?hc Method for Piles Driven in Clay
This paper presents a tentative method for evaluating the limiting skin friction f//s for piles driven in clay based on sigma //h'c (horizontal effective stress at the interface...
Site Characterization Using the Cone Penetrometer Test
The Cone Penetrometer Test (CPT) when used in conjunction with a limited soil boring program can provide a more detailed and economical site characterization. This paper addresses how...
Analysis of Liquefaction Potential by Insitu Testing
This paper describes the results of insitu testing performed to assess the liquefaction potential of a sand formation at a site for a proposed large industrial facility in East Central...
In Situ P and S Wave Velocity Measurement
A review of the in situ techniques to measure P and S wave velocities by seismic wave propagation is presented. A relatively new technique, the suspension PS logging method, is described...
In-Place Permeability Measurement of Slurry Trench Cutoff Walls
A suggested procedure for the in-place measurement of slurry trench cutoff wall permeability is presented. The H. Bouwer and Rice method, employing a single observation well and variable-head...
Use of Piezometer Cone Data
The piezometer cone is generally regarded as the most efficient tool for stratigraphic logging of soft soils. A thin pore pressure element (5 mm thick) can sense layers a few centimeters...
The Pressuremeter for Foundations: French Experience
The paper presents historical information on the development of the pressuremeter and its application in the Laboratories Central des Ponts el Chaussees (LCPC). The continuous research...
Return to search