Undrained Cyclic Behaviour of Beaufort Sea Silt
Cyclic loading behaviour of Beaufort Sea silt has been studied under triaxial conditions, with and without static shear stress, to define the resistance to liquefaction or cyclic straining...
Arctic Oil Spills in Relationship to Sea Ice Motion
Sea ice on a scale of a few kilometers must be treated as a granular material rather than a continuum. The floes are in nearly constant motion relative to a fixed frame and each other....
Constitutive Equations for Ice as a Damaging Material
Constitutive equations for ice subjected to uniaxial compression are developed based on applications of the theory of continuous damage mechanics. A physical model of ice deformation response...
Fracture Theory for Nonhomogeneous Brittle Materials with Application to Ice
Brittle heterogeneous materials generally fracture with a dispersed zone of microcracking at the fracture front. The deformation and failure of these materials can be described by a nonlocal...
Mixing Steel and Concrete
For highrise structures, mixed steel-concrete systems are more efficient and cost less than either material alone. The two design approaches are exterior tube structures and core braced...
Use of Rayleigh Waves in Liquefaction Studies
The Spectral-Analysis-of-Surface-Waves method is a new seismic method for efficient determination of shear wave velocity in situ. Vertical impacts applied to the ground surface are used...
Computer-Aided Studies of Complex Soil Moduli
Low-cost microcomputers and new electronic components make it possible to measure accurately the phase and amplitude of mechanical waves in the frequency domain at a small fraction of...
Seismic CPT to Measure In-Situ Shear Wave Velocity
A new test, called the seismic cone penetration test (SCPT) is described. A small rugged velocity seismometer has been incorporated into an electronic cone penetrometer. The combination...
Relationships between Shear Wave Velocity and Depth of Overburden
Relationships between in-situ shear wave velocity and depth of overburden have been derived for various Quaternary age soils encountered primarily in Southern California. The geotechnical...
Case Histories: Evaluation of Drilled Pier Integrity by the Stress Wave Propagation Method
The Stress Wave Propagation Method (SWPM) was used to nondestructively investigate the integrity of straight-shaft drilled pier foundations at two sites in the Denver, Colorado area. Drilled...
Behavior of Drilled Piers in Layered Soils on Texas Barrier Islands
Twenty-eight full scale load tests and the results of 41 geotechnical studies were analyzed to correlate shear strength interpreted from field and laboratory test data with those derived...
Landslide Hazard Rating for the Oregon Coast Range
The landslide hazard rating system for shallow soils on steep terrain over hard sandstone has three components: ground water response to precipitation, soil shear strength (including root...
Abutment Seepage at Smithville Dam
After initial filling there was concern for the stability of Smithville Dam when higher than anticipated piezometric levels were experienced in the left abutment foundation. Concern heightened...
Some Aspects of Analysis and Prediction of Subsidence
A procedure based on the nonlinear finite element analysis was investigated for the prediction of subsidence caused by longwall mining. This paper presents a case study involving predictions...
Application of Displacement of Discontinuity Methods in Underground Mine Design
Displacement discontinuity methods for stress analysis, pioneered by Starfield and Crouch (see, for example, Starfield and Crouch, 1972; Crouch, 1976; and Crouch and Starfield, 1983),...
Fracture Mechanics Analysis of Massive Hydraulic Fracturing Containment
The hydraulic fracturing containment problem is the subject of the present investigation. Unlike previous studies, the interface crack geometry with the correct crack tip singularity was...
Modelling of the Fracture Process Zone in Rock
There are a number of situations in the fracture mechanics of rock in which linear elastic fracture mechanics (LEFM) concepts are inapplicable or insufficient. Two such situations are...
Simulation of Rock Fracture with the 3-D SHALE Code
The 3-D SHALE code simulates the propagation of stress waves and the occurrence of fracture in brittle solids. The physical models and numerical methods in this code are similar to those...
Can Clay Liners Work?
Nearly all liners for landfills and surface impoundments were constructed from compacted clay until about five years ago. But this is no longer so. In the past few years, clay liners used...
Bond Stress of Embedded Steel Shapes in Concrete
This paper describes an investigation into the bond stress developed between steel shapes and reinforced concrete when the concrete is lightly stressed. A brief discussion of previous...
Return to search